1998 Mitsubishi Mirage Hub Bearing Repair
Loading...
Loading...
3,772
Loading...
Uploader Comments (APDTY)
see all
All Comments (7)
-
Man, and I really struggle in installing the steering knuckle to a Honda Element, most of the Japanese front -wheel drive are pretty similar in the hub install
-
I had to replace the bearing on a 95 Mazda Protege before. I fiqured I was going to need a press. But then I had the idea of pulling a used spindle and bearing assembly. Cause I found it was cheaper to get the whole thing used from a self serve wrecking yard then buying a bearing + to press it.
-
Very Informative. Thank you for this nice video.
-
cool
-
nice video. You split the boot of the lower ball joint, i saw grease squirt out of the boot when you were hammering it... easily done
Loading...
6:25
Service U-joints in minutes using the Tiger Tool 10105 U Joint Puller & 10202 Bearing Cup Installerby HowToolVideos16,527 views- 2:47
Bolted Hub Wheel Bearing Removal Walkthroughby richpin06a37,249 views
- 0:33
Unlock your car with a tennis ball!by 11beeber1,808,050 views
- 0:29
VERY BAD Ball Joints - WATCH THIS!!!by haglinautomotive186,692 views
- 7:03
How to replace front wheel bearing. 00 - 04 Mitsubishi Eclipse (part 1 of 3).mp4by fueledbymusic332,055 views
- 0:21
How a worn wheel bearing sounds.by Bobbyhax63,791 views
- 7:42
Diagnose Window Motor and Regulator Problems and Repair Part 1by APDTY46,223 views
- 2:07
96 Pajero wheel bearingsby 4wdadventures3,057 views
- 0:47
How Do I Tell If I Have a Bad Front Wheel Bearing Hub Assembly? 1AAuto.comby 1aauto161,714 views
- 5:43
1993 Honda Civic Del Sol Wheel Hub & Balljoint Removalby GrindTimeAuto27,526 views
- 3:59
Front wheel bearingby realfixesrealfast437,616 views
- 7:04
how to replace front wheel bearing. 00 - 04 Mitsubishi eclipse (part 2 of 3).mp4by fueledbymusic310,440 views
- 0:22
Wheel bearing buggeredby TeJero992,594 views
- 7:47
How To Replace a Honda Civic Rear Wheel Hub Bearingby roygillin5,280 views
- 13:23
How To Replace Wheel Bearingsby canobd2188,169 views
- 7:51
Removing the Passenger-Side CV Axle - AutoZone Car Careby AutoZone27,364 views
- 3 videosWheel Bearing Replacement Eclipse
- 5:07
How to Install Hub Bearingsby primechoiceauto79,822 views
- 9:57
2006 Pontiac Torrent Hub Bearing Repairby APDTY24,122 views
- 3:47
Replacing of hub and front wheel bearing universal 1090-20by WallmekAB1,314 views
- 4:26
Hub Busterby hubbuster96,518 views
The lower ball joint tight nut, is not tighten up! How do I get it to tighten properly!!
JDPATO 2 months ago
@JDPATO You may need to apply pressure on the lower ball joint, so that it is forced to sit tight against the control arm, the easiest way to do this on these cars is to place a floor jack direcly under the lower ball joint, and jack it up slightly until the ball joint is pushed into it's receiving hole. Once that happens you should be able to tighten ball joint nut.
APDTY 2 months ago