Winter-Test EasyStar / FlyCamOne 3

Elektrosegler EasyStar (Multiplex; Brushless-Motor) mit FlycamOne 3 (FCO3 V2, Firmware D1 mit 720x480 Pixel; ACME) und 5.8 GHz-Videotransmitter; Winter-Flugtest (-4°C, böiger Wind) im November 2010 bei München-Pasing; immer wieder gut zu erkennen: das Münchner Westbad (elliptisches Gebäude mit Außenbecken, z. B. bei 01:48);
keine Probleme bei ca. 45 min Flugzeit; Akkus auf ca. 35°C vorgewärmt, FCO3-Versorgung aus Flugakku mit RX-Kabel (nur bei V2 möglich);

Category:

Science & Technology

Tags:

• easystar
• rc airplane
• Modellflugzeug
• BL
• brushless
• onboard
• camera
• kamera
• ACME
• FCO3
• patch
• antenna
• flycamone
• FCO3 V2
• Luftaufnahme
• Flugmodell
• Flug
• FPV
• flight
• transmission
• Immersionsflug
• aerial
• photography
• mpx
• multiplex
• model
• aircraft
• panorama
• felder
• schnee
• wolken
• sonne

[RCcunuk]

with all of the snow, are you not afraid of damaging your motor , ESC or other electronics?

Nice flight and location

[DocMedicus]

@RCcunuk Until now, I have only positive experience with winter flights. It's important to pre-warm the LiPo before start (ca. 35°C is fine). When the canopy is closed, the EPP fuselage is a good isolator and protects the electronics well. Only the camera is exposed to the cold air, but it works completely normal. Of course I pay attention to avoid contact between snow/water and the electronics.

[OlegOx]

very-very nice

where is this place?

[DocMedicus]

@OlegOx Thank you! This flight was near the western suburbia of Munich (Southern Germany).

[MrHelidude]

It's a pity that the landing was not included.......

[MrHelidude]

Very nice. Snow scenes are always beautiful.... :-)