#3 H2O2 - Applying Transfer paper to PCB, Part 2

Update 11/27/2008: When soaking The Paper in water place 2-3 drops of Dish soap (Surfactant) in Vary Vary hot water and let soak about 1 hour. This will cause the water to penetrate the paper and it will come right off.

Part 2 of a 4 part series. This is the Ins and outs of applying Transfer paper to a PCB surface mount or standard through hole and will work for any project.
The Paper is STAPLES "photo basic gloss" Item#666176 4x6in but any size of STAPLES "photo basic gloss" will work.

Category:

Science & Technology

Tags:

• PWM
• V2
• Current
• Limit
• Zero
• Fossil
• Fuel
• ZFF
• HHO
• ZPM
• improvements
• surface
• mount
• ZeroFossilFuel
• free
• PCB
• Layout
• Free
• alternative
• energy
• DIY
• part

[H2O2FromH20]

LIiutaio Said : "Gee, plain paper loose easier than this!" Translation.

I will have to try normal paper.

This was the second time I had done this process.

I now use 120Deg F water mixed with dish soap, the Water now penetrates the paper and there is very little rubbing. It almost falls off in one piece .

[H2O2FromH20]

I really need to know if this is helpful drop me a line and give me some feed back.

[KazKylheku]

How about putting the guide dots farther out from the edge of the board. Then there is less alignment error due to the thickness of the board. Also, put them farther apart from each other: less rotational error.

[LIiutaio]

Pô, papel comum solta mais fácil que este!

[joy87pl]

Cold water is better!

2 minutes and paper alone leaves...