Spyder vs1tips tricks and upgrades part 5 of 5
Uploader Comments (sjking92)
All Comments (34)
-
@sjking92 ya its not that expensive i was just wondering thanks dude
-
where in texas?
-
And also is the Tadao Spyder VS Marker Board good for my vs1 which is the exact one you are holding in your hand except without the whole drop thing and ASA stuff and where did you get that?
-
It sounds like it is the detents from what you are describing. To replace the detents, unscrew the "eye covers" there, you will find the eyes and another little hole near the eyes. These are the detent holes. They should be plugged in by a detent. If they are there, take them out by taking off the barrel and pulling back the bolt and sliding your finger inside the breach and popping them out. Inspect them for wear. But it sounds like you need them replaced. Unfortunately, idk where to get them
so when i have my tank in dont take the bolt out
mast3erb3ar9 1 year ago
@mast3erb3ar9
That's always a good thing to not do with any marker.
sjking92 1 year ago
@sjking92 normally the air presure keeps the bolt in, and btw spyders r fucking gay i only watched this cus i was board get a real gun
LEGIONofDOOMpbteam 3 months ago
@LEGIONofDOOMpbteam
This video was filmed in 2008.
Congrats. I do own higher end markers, and "real" guns.
sjking92 3 months ago
hey do u know if the ans drop forward for spyder will fit this gun????
PBZeno 1 year ago
@PBZeno
They should. Drop fowards have 2 different types of attachments. In line screw, and off set screws. They are now being made with both inline and offset. So I think it should be fine.
sjking92 1 year ago