Huxley printing at 50mm/s
Loading...
Loading...
74
views
Loading...
Link to this comment:
Share to:
Uploader Comments (microcubology)
see all
All Comments (3)
-
Hello…
You have a nice looking printer. I am building a RepRapPro 3d Printer.
The 50mm/s speed seems to be working fine with your configuration. I would like to know how you set this up.
Loading...
- 4:20
RepRapPro Huxley 023by RepRapPro61 views
- 1:02
eMAKER Huxley printing a hexbowlby burtyb11,059 views
- 2:32
Help required to tune RepRap Pro Huxleyby Alzibiff122 views
- 1:20
RepRap Huxley Printing a Drive Cogby johnchipabs60 views
- 7:31
Huxley_FirstPrint01.aviby TheGsoffer38 views
- 1:40
eMaker Huxley - Printing using Slic3r V0.6.0by smartroadbiker114 views
- 0:59
Reprap huxley printingby cyborg52768 views
- 0:24
Time Lapse 3D Printing on Huxley - Reprapproby MaximSachs151 views
- 2:35
eMaker Huxley First Printby zeugundso148 views
- 0:18
First print! Hello 3D World!by mophys1750 views
- 8:29
RepRap Huxley - printing snowflake - test 3by MikeMikeBMX174 views
- 5:27
RepRapPro-Huxley21.flvby RepRapPro75 views
- 1:17
First Reprap huxley printingby cyborg527129 views
- 6:10
RepEap Huxley - Printing a Snowflakeby MikeMikeBMX48 views
- 0:41
eMaker Huxley 3D Printerby mordac100207 views
- 1:52
Reprap huxley "AClara" printing itself a replacement partby kaosat191 views
- 1:02
Reprap huxley "AClara" higher speed testby kaosat203 views
- 0:33
Humbie huxley printing at 190mm/sby romscraj55 views
- 0:36
huxley printingby canuckscottsmen165 views
- 0:26
Twistable Heartby microcubology98 views
The quick answer is just go into Skeinforge/Settings/Quick Edit and change the Feed rate and Flow rate values to 50.
The months of preparation that led up to being able to do that are summarised in a post called "Skeinforge Configuration" in the RepRapHuxley Prints section of the RepRap Huxley forum.
Good luck with your build.
microcubology 1 month ago