Engine Dyno Pull @ Street & Strip

This was a dyno pull on a 2300 Ford engine running a Holset HX-35 turbo. We were testing pre-cmpressor water/meth injection.

Category:

Autos & Vehicles

Tags:

• dyno
• pull
• engine
• street
• strip
• ford
• 2300
• holset
• hx35
• turbo

[PlatoTacitus]

hehe... nice! Especially the exhaust manifold in the end, glowing red hot:) Nice power, but torque figure is a bit low.

[99GSTracer]

Thanks, man. This same engine made 585 HP and 480 ft/lbs TQ last year on 28 psi and a slightly more aggressive tune.

[99GSTracer]

450HP and 389 ft/lb torque on a stock engine using a Holset HX-35 @ 22-23 psi.

[torque395]

@99GSTracer Totally stock engine other than the HX-35?? No head or main studs, o ringed block/head, copper head gaskets, aftermarket rods or pistons? I am building one of these engines and was under the impression that 300hp was about as far as I could go with all stock components.

[splashoyellow]

what were the numbers on that little engine? just curious cause i got a 2.3 sitting in the garage and was thinking or turbocharging it.