Soldering the control board for the 144v 500amp controller

This shows all of the steps of soldering the control board from start to finish. I show how to verify the correct orientation for each of the component types and how to solder to the ground plane.

Category:

Science & Technology

Tags:

• control
• board
• 144v
• 500amp
• revolt
• controller
• DC
• brushed
• series
• wound
• EV
• electric
• car
• open
• source
• global
• warming
• DIY
• homemade
• home
• made

[Sohave]

Hi I hooked mine up and the green led lighted without flashing

[MPaulHolmes]

@Sohave The green LED will stay lit and not flash, because it's just showing that the 12v power is there. The yellow LED should flash if you don't have the current sensor or throttle hooked up.

[xtevesss]

Excellent job.. i just have a simple question: Where you ordered/made the board? thank you!

[Sohave]

@MPaulHolmes Hi sorry from not removing that post it was from back when i hoocked it up to a too low woltage and it automaticaly shut down. The controller is Currentley working Fine. I will put a video up of it soon.

[Sohave]

Thanks for the instructions Paul I apriciate that.

[bandayho]

hi you say you sell these kits how can i get one, my email is bandayho@aol.com