Uploaded by etrailertv on Jun 12, 2008
http://www.etrailer.com/tv-hitch_install_2006_dodge_ram.aspx
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Today we are going to install part number 75151 from Draw Tite. We will install this on a 2006 Dodge Ram full size pickup. First step involves in some models you might have to lower the spare tire. If you have enough clearance between the bumper so you should not have to lower it. The next step is to go ahead and lower the plastic plate here. There are 4 tabs in the bottom you squeeze so you can flip this up out of the way. To remove the plastic piece these 2 tabs have to be squeezed on the bottom and pushed upwards. Next we install our hardware into the bumper itself. We just a carriage bolt in and the edges will ride in these little holes here a little bit. It kind of sticks up you can see it rock a little bit. We you tighten it down it will pull flush into it.
You can go ahead and install our hitch hanging from these 2 bolts. Next all we have to do is fish wire the bolts into the bumper and pull them out of the back pointing that way. We will go ahead and leave this loose so we can go ahead and have some wiggle room for the bolts to come through. We ran our fish wire into the frame here and what we are going to do is pull it up and through the side of the frame. Make sure you slide your plate on the wire first and then go ahead and thread on your bolt. Pull everything right on through and there you have it. At this point make sure you do not lose the bolt in the frame. Go ahead and repeat for the other side. Once you have all your hardware installed you can go ahead and move it a little bit. Try and get it as center as possible then go ahead and snug down the bolts. After that we can give the bolts their final torque. As you tighten these down you can see the bolt sink into the bumper. Now we can pop our plastic plate back on. That covers it for part number 75151 from Draw Tite.
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
-
2 likes, 0 dislikes
3:25
Trailer Hitch Installation - 2008 Dodge Ram 1500 - etrailer.comby etrailertv3,340 views
5:12
Trailer Hitch Installation - 2006 Dodge Ram 1500 -etrailer.comby etrailertv5,440 views
7:09
Fifth Wheel Trailer Hitch Installation - 2004 Dodge Ram - etrailer.comby etrailertv12,600 views
2:16
Trailer Wiring Harness Installation 2006 Dodge Ram - etrailer.comby etrailertv8,629 views
8:53
Recon Cab Light Install Dodge Ram Part 1by frogaliscious19,431 views
0:33
Dodge SRT 10 Burnout and Roll Over Crash www.qwreck.comby qwreck12,645,287 views
1:27
How To Lower Your Spare Tireby gardencityjcd9,848 views
0:49
2002 Dodge Ram Dual Mufflers Flowmasterby selerim1,751 views
0:31
Lowered 08 dodge ram 4.7 custom exhaustby bigrandy3215,290 views
1:48
Install Curt Trailer Hitch - AutoAnything How-Toby AutoAnything19,497 views
8:30
02-05 Dodge Ram Dash Cap Installationby firefighter487914,132 views
0:55
2011 Ram Long-Hauler Conceptby carmgn9612,703 views
2:26
The Power of a Dodge Ram 3500 Cummins Dieselby benzter84110,466 views
2:55
Dodge Ram , Summit shorty headersby bhrodeoaz16,987 views
1:38
The Hitch Hogby TheHitchHog31,902 views
1:53
2006 Dodge Ram with 4.7 w/ single chamber flowmastersby SoutherRedneck8822,990 views
1:13
Convert-A-Ball Adjustable Cushioned Ball Mount Review - etrailer.comby etrailertv870 views
0:46
Dodge Ram HEMI VS. Ford Mustang GT (messing around)by badtekker990,492 views
0:24
Dodge Ram Crashes Bank- MUST WATCHby particletheory152,245 views
3:38
Trailer Hitch Installation - 2007 Nissan Xterra - etrailer.comby etrailertv2,050 views
- Loading more suggestions...
Link to this comment:
All Comments (0)