95 Chevy Suburban with a cummins 12 valve installed.mp4

My friend Rob installed a 12 valve cummins in his 95 Chevy Suburban and he did a real nice job it just needs more fuel now.

Category:

Autos & Vehicles

Tags:

• chevrolet
• Chevrolet Suburban
• Cummins
• racing
• 4x4
• offroad
• Four-wheel drive
• motorcycle
• outdoor sports
• mud
• cummins
• conversion
• Diesel
• 6.5
• turbo
• diesel

[TxBigRyan]

Did you use the stock transmission?and it did it bolt right up? I have a 5spd in my 97 chevy 1ton trying to figure out if I can keep the stock tranny with the 12valve swap.

[Needmorehorsepower]

@TxBigRyan I believe Rob used an nv4500 for the build which was made for dodge and for chevy with just a different input shaft,he just snapped the input shaft or the t case went to hell you will need the cummins bellhousing for the nv4500 trans also but if you go to Robscoalroller there is a video of the trans and a disription of it he will be doing a new video coming soon on it but he has to get his 454 5 speed truck running 1st its his daily driver

[1988diesel]

@Needmorehorsepower what size input shaft is rob using in the suburban? I know the input shaft and bearing retainer are Dodge.

[Needmorehorsepower]

@1988diesel I think he had the trans split and the dodge input shaft installed i will have to have Rob answer about the bearing retainer

[RollinSmokeHigh]

Cool build I'm doing a 97 suburban with 10 inch lift and solid axle swap and an nv 4500 wit a divorce mount np205, any tips you can offer.

[Needmorehorsepower]

@RollinSmokeHigh This was built by my buddy rob his channel is Robscoalroller his camera was lost and i did all the down loads so i posted this on my channel from my camera after the build was complete you can try and put a post on his channel and he will answer you there im sure of it there is a link on my channel to his channel good luck with the project :)

[CORVAIRWILD]

'92 93? I think. round steering column. u can do my white Phoenix one next!

[Robscoalroller]

Txbigryan, you can use the 97 nv4500 you just have to put a dodge input shaft and bearing retainer in it. I will try to make some video of mine when I pull it back out of there. I will be rebuilding both the transmichigan and transfer case while they are out.....again :(

[Robscoalroller]

Hey im pretty sure I used the 1.25 inch 10 spline input shaft , just broke it monday so I guess im goin to a billet input shaft. Only advice good luck , take your time, and be patient! Its so worth all the elbow grease and blood haha!

[TheKrankieV]

@Needmorehorsepower I'm gonna have to have a case of that pretty soon... I have a lot of videos filmed but in need of uploading