TM 5.1 Hi-Capa Complete Disassembly Part 2

Shows the disassembly of the grip portion of the pistol

Category:

Sports

Tags:

• TM
• Hi-capa
• 5.1
• WE
• airsoft
• pistol
• dissassembly
• take
• down
• strip
• stripped

[collinblondy12]

hey i have a high capa 5.1 and it shoots full auto. what could i do to fix that?

[TheEarthwalker]

ive never encountered that problem before but it sounds like the trigger is not disengaging, take the slide off and look at the inside of the grip, pull the hammer back and push down the little silver tab that pops up on the left side of the hammer, then pull the trigger and hold it and cock the trigger again, if the falls with the trigger still held then it sounds like the sear is broken

[MastahSmith]

excuse i try to disassemble my lower frame but my gun shoot in full auto what shall I do?

[TheEarthwalker]

ive never encountered that problem before but it sounds like the trigger is not disengaging, take the slide off and look at the inside of the grip, pull the hammer back and push down the little silver tab that pops up on the left side of the hammer, then pull the trigger and hold it and cock the trigger again, if the falls with the trigger still held then it sounds like the sear is broken

[thesuperbosses]

the Hammer wont lock in when i put my slide on and cock it but it will when i take off the slide and pull the hammer back i dont know what to do any suggestions

[TheEarthwalker]

take a look at the picture of the three metal tabs and compare it to yours if you havent already, they have to be in the same position as the ones in the pic

[BryanBrockAndrews]

My hi cappa is having trouble blowing back all the way. I'm not sure why it won't. It blows back just far enough to pull the hammer off the valve, but not far enough to reset the cycle. I end up having to pull the slide back to fire another shot. I figured putting a new spring in would fix the problem, but it didn't. Any suggestions?

[BryanBrockAndrews]

THANK YOU Worm! I disassembled my hi cappa to replace the spring, and I couldn't figure out how those safety bars were oriented. You saved me a world of aggravation.

[TheHartAtk]

on the picture, i cannot see the prong on the right. Is it under or above the silver piece?

[AirsoftTech95]

thank you so much for that picture at the end.

[Sire347]

Dude thank you so much for posting this video. I didn't have the prongs set up right and you showed me how and now everything is good!

[mxjoe388]

hey i have a WE high capa 5.1. it wont stay cocked. i can pull back the hammer but if wont stay back. any ideas?

[markkus2007]

What should i do when my slide gets little stuck but not too hard when i slowly move the slide. When i let the slide move fast like it should then its okay.

[betz1120]

@TheEarthwalker My 13 year old son recently disassembled his WE 5.1 gun and it now is now only shooting one time and then it releases all the gas after the shot. I am following your video to disassemble the bottom portion and there seems to be something not quite right....the part on this video where you say you really dont want to disassemble because it is very difficult to get back together right...well thats the part that is disassembled...any way you can show me how to assemble that part?

[Iizmstrcheef]

@MastahSmith read my reply to "collinblondy12" its got instructions on how to fix it