Wicked Wheel Install
Loading...
20,274
Uploader Comments (pitfool03)
see all
All Comments (25)
-
I would NEVER let this guy touch my truck
-
Thats about the right torque.........hehe
-
also do i have to do anything to my "foiled pipe"?
-
@richallen915 its suppose to spool up faster and sound better too(doesn't hurt)
-
@pitfool03 might be a good time for a ccv mod while I'm at it. Did ya'll do a racor mod or anything?
Loading...
so i have my WW in hand Marty... are these the steps:
- remove intake manifold/hose
- loosen v-band clamp and slide off onto the charger
- remove the bolts holding the intake side of the charger on
- pull the charger side off
- impact the old wheel off
- impact the new wheel on - hand start
- put everything back together.
what about the wastegate? and what is the ccv?
gibsonguy400 1 year ago
@gibsonguy400 Take the intake y out of the way. There is a little clip on the wastegate that allows you to pull it off with the compressor side of the charger. If that doesn't work... the two 10mm bolts will work too.
The CCV is on the intake tract.
pitfool03 1 year ago
This reminds of when Bruce Willis was desmanteling that nuke on armegedon. How to you disconnect the intake tube from the ccv?
rammertide07 1 year ago
@rammertide07 loosen all the clamps and then rotate it counter clockwise and pull up on it.
pitfool03 1 year ago
So if you gain no power what is the point of this?
richallen915 1 year ago
@richallen915 Surge Reduction
pitfool03 1 year ago