Micro Servo - First Prototype

First prototype of my micro servo project. AUW is a bit less than half a gram.

Category:

Science & Technology

Tags:

• DIY
• micro
• servo
• r/c
• plane

[mixmanilla]

weight?

[angrymonk55]

@mixmanilla

~450mg w/o wires.

[Flyingwigs]

very cool :D

so is the driver on the end of the frame there, or is it separate like the HK linear servo?

[angrymonk55]

@Flyingwigs All the controls are crammed into the end.

[vanepico]

How does this compare with the ones for he ar6400? I guess it will last longer with the hall effect sensor as opposed to the PCB mounted potentiometer

[angrymonk55]

@vanepico I haven't looked at the ar6400's a lot but this one is about the same speed, about a third the weight, but probably has less load capacity.

[48ghmmp]

Surely this item would be so attractive to the modelling industry. I know it is perfect for my Railway modelling on DCC control.

Have you tried to get it mass produced??

[jevries]

Looks very good! Where the potentio part?

[RalphHarr876]

KEWLZ !!!!!!!!!!!!!!!!!!!!!!!! So tiny. I made one like that too. Well in know im ony 13 but i culd build a better one, but you have to tell me how first then i could do one to.

[MalliaCamilleri]

Big tweezers!!!!!!!!! put it up against your hand.

[rockonmyfriend]

awesome man! hey?... how exactly did you make that reeallyyy small motor for your insanely small plane?