Pure Hydrogen 24 Volt Separator Cell System Part 2 Time Lapse Duration Test

Much thanks to The Farmers and to Jody Weger for letting me steal his music. Great tunes!

This system is using a Hydrogen / Oxygen gas separator cell. Yes it fractures water in to gas, but it also separates the two gases in order to lower the burn rate of the Hydrogen. I'm in the first few initial runs with this new set up and so far I am quite pleased.

Discussion at EnergeticForum.com here http://www.energeticforum.com/renewable-energy/8078-separator-cell-hho-resear...



The separator cell kit and PWMs are provided by HHO-research.com.au and they work great. With this system I've upgraded to 1/2" tubing from 3/8" to allow for easier passage of the over flow electrolyte back down into primary tank. The amplifiers are 30volt (max) @ 50amp supplies and were previously used to transmit a FM radio station.

In this video i'm doing a long duration test at 28volt and between 12 and 10 amps on either power supply. Temperatures on the actual cells are around 28 degrees Celsius at the beginning of the test at 01.35.00, and finish after a burning run of 1 hour and 21 mins the cells finish up at a temperature of 43 degrees Celsius at 02.56.00 on the real time clock.

Love and Light

Category:

Science & Technology

Tags:

• Hydrogen
• oxygen
• energy
• electricity
• stan
• meyer
• bedini
• eric
• dollar
• peter
• lindemann
• tesla
• zero
• point
• attraction
• motor
• muller
• generator
• hho
• gas
• fracture
• water
• fuel
• renewable
• global
• power
• warming
• change
• climate
• solar
• green
• free
• wind
• environment
• clean
• alternative
• magnet
• save
• build
• america
• diy
• technology
• magnetic
• climate change
• earth
• bill
• efficient
• engine
• coal
• efficiency
• security
• instructions
• cheap
• carbon
• review
• recovery
• cost
• fossil
• grid
• national
• eliminate
• dirty
• economic
• free energy

[losttreasurehunt]

Do a video on how pure it is, if it is a true hydrogen or HHO.I'm curious

[darcyklyne]

@losttreasurehunt I could try and show you but you have to know that oxygen burns with a bright yellow to white spectrum and very fast. Some times the electrolyte you use can color the flame as well. A gas volume meter test would indicate that the H2 moves twice as fast as the O2 side (venting out in to room). An there is no flash back at all on my H2 side as you see in HHO gas it whifs out quieter than a candle. will try make video if i have time. work season is upon me.

[losttreasurehunt]

@darcyklyne Thanks man ,your doing some great work

[darcyklyne]

@losttreasurehunt sweet. I appreciate that losttreasurehunt. make sure and check out hho-research's videos as well for more validation. And i will do a real gas quality test some how. volume flow alone isn't probably good enough for proof, so to speak. Its in my best interest to know exactly how pure it is, so i'm going to find some testing equipment before i try to bottle Hydrogen to know i'm not pressurizing O2 as well (dangerous).

[darcyklyne]

@losttreasurehunt I should say the hydrogen burns in a blue-ultraviolet spectrum. Ambient oxygen in the room as well as venting do react on the outside of the flame. I'm not out to try and prove this to anyone. These videos are meant to show that this IS possible. But ultimately, if you don't want to take it for what i'm saying it is. Thats your choice too. :) If you make it to end of this video i pan up and show where the lines for O2 are running a bit.

[darcyklyne]

@amos033 As well. you can not take the readings on the PWMs. I'm supplying just under 10amps @ 28v on each on to each PWM. displays on PWMs are set up for 12v readings so these indicators are not correct on them.

[darcyklyne]

@amos033 Although I appreciate your input, i'm not exactly sure how you have the experience with my set up to give me those figures, or deny its potential. Pure hydrogen does not equate the same as HHO gas. I can mix my oxygen back in and control my burn rate, as well my generator is using a GEET reactor and reprocesses my exhaust gasses. Blanket statement of LPM.. too many variables to make one like that.

[darcyklyne]

@blairaudio You know it Blair!

[darcyklyne]

@myhydrogencar Thank you so much Peter. I'm feel like i'm really getting a pure representation of hydrogen in this video. The real ultraviolet color is showing up and if i'm not mistaken, I'm seeing oxygen reacting in a combustive flash at the perimeter of the hydrogen flame throughout most of this video. I've noticed that even when i burn the torch in too close vicinity or near where oxygen is dissipating that the flame can become colored with abundance of oxygen. Does that sound right to U

[blairaudio]

The farmers are awsome.