My 3,5 hp Briggs with mods

This is my Briggs and Stratton 3,5 HP with:
- 14-12 DelLorto carb
- custom Muffler (Vers. 1.0)
- custom air filter
- engine totally cleaned
- modify to work vertically (only about a litre of oil)

i think i'll build a kart with...

Category:

Autos & Vehicles

Tags:

• briggs
• and
• stratton
• go
• kart
• quad
• buggy

[Blackh2sut]

ohhh...wie süß =)))

[zimone89]

ich weiß

[gaspowerrules]

@zimone89 was that a bottom shaft motor if it was cool also did u build a cart

[zimone89]

@gaspowerrules of course!!!!!now i've found a new bigger and better carb from a 6HP...i want to try to use also 6HP's cams....then i'll solve the problem with the oil cap and the problem with the shaft and the clutch hole (the clutche's hole is 1/4", instead the engine shaft is 1/2")...

[zimone89]

yes, of course...now i've made a nicer muffler...there will be a new video....i' had only a problem....the oil's cap isn't very good and the oil slowly go out...i'm trying a new o'ring...or a new cap in future...XDDD

[geoff390]

It'll seize soon unless you modify the oil slinger, anyway good job on the muffler and carby.

[gmc07joe]

i think it seized at the end there

[TRcustomengineering]

I always put my engines on dirt when i test run them like that so when it's shaking around it don't break the block.

[gaspowerrules]

@zimone89 cool is there a vid

[jack9102]

@livesteamfan1 opps :S i feel like a fag.. this engine was most likely mounted on a snapper er something like that

[livesteamfan1]

It appears to be an older engine, so, it possibly has a heavier flywheel.

[420witchdoctor]

That still runs.

[jack9102]

thats a fucking lawmnower engine it'll sieze if you dont put an oil slinger on it and how is it runing without a blade? mine ran like shit when i did it

[mrsuperhooper]

What a piece of junk!