Flyback Driver, High Voltage in 5 minutes
Uploader Comments (sparkfishes)
All Comments (16)
-
@zezimashock - look up neon store in you phone book or signs and buy a neon sign transformer for 30$ and you dont need to build anything, and never heats up and you can draw 3 inch sparks starting at 1 ich, mine is 12kv, at it is meant for pulling arcs on and you can run it over night and will be stone cold in the morning
-
Glad you liked it and got it to work
You could now make a Jacobs ladder and then go on to Automobile Ignition coils which will take more amps - see my TESLA COIL ALSO
-
i got a video showing my working place around my flyback and stuff if your intressed you could take a look :)
-
about a year ago I didn't know what a flyback was , wich I wish I did because the people next to me wear throwing out about 20 old tv's/monitors
i think you need to use the old type,
the newwer types do not give that much output :(
i tryed it with a older version and a newer one.
zezimashock 3 years ago
The newer ones will work it is just that some need a capacitor in the line . That was the point of the video : to show the next stage from what other people had shown could be done with the old ones
The new Flybacks give out the same HV as the old ones
sparkfishes 3 years ago
i know you need a cap in the line :)
olderones (here ) work better.
but still i get only 1 to 2 cm arc's :(
zezimashock 3 years ago
Try different values of Cap ( I think? that going smaller improved spark length)
Also get the Biggest value ( watts) CFL you can
- It is still not as good as driving the flyback with a separate driver and increasing the CURRENT
sparkfishes 3 years ago
i made a separate driver for my flyback :)
i think i am going to let those cfl thingies alone and focus on my flyback's driver more :)
zezimashock 3 years ago
You get more power if you drive from a separate driver
Even with a 12 volt 6 amp battery you get big fat sparks
The simple one transistor circuit works well and is robust
sparkfishes 3 years ago