Whipmag mpmm newbe large rotor test

Using Diametric discs for rotor. bah what da heck.

Category:

Science & Technology

Tags:

• magnet
• magnetic
• motor
• free
• energy
• whipmag

[Magnetmad]

HI

Nice work it looks realy Good, very smooth

[Magluvin]

Thanks

This was more to to see the effect of a larger than prescribed rotor upon the stator. Since the diameter is greater than prescribed, the gap between rotor mags is larger, the stator pauses quite a bit between whips. But AGW was there. It really makes me wonder if it could be made to work with 1 stator, and its just a matter of finding all the right variables. I realy like your settup. Very sweet.

Check out my new vid, Robowhip

[Magnetmad]

Cheers,

1 stator! Ithink u would be dispointed here, on its own the stator can not pull the crown wheel,I have tried this,i have not been able to get it to speed up, but i can get it to run for 4 mins + when the 2 stators are stopped without them it only runs for 30 sec's If you hold all 3 stators stopped and spin the crown wheel on its own you will see the same effect.

I am nealy done with my lastest attempt. and i feel that this could be it

If you want to chat leave me a message!!

Dave

[Magluvin]

Hey Dave. I doe see what you mean. The 2 idlers definately add a positive attribute. Have you tried a timed spin down with all stators(3) in gw? also w/out stators? I was having problems with my bearings. I soaked them in wax and grease remover and they seemed very dry and they spun up sweet, but after a bit, they seemed to tighten up a bit. It's hard to get gw on 1 of them. I figure some grease was still in there and I really need to blow them out after soaking. Even oils slug it up.

Magluvin

[Magluvin]

Knowledgemonger always has something negative to say of my stuff, But you should see his videos, oh oops, he doesnt have any cuz he is too busy discrediting others. This is one of my oldest vids and he is still here trying to make things look bad on my part. Fun fun fun.

Magluvin

[Gokulhraj]

is this really works?



[RonRay]

I made a typo in my previous statement: I meant to say "YOUR" designs seem to be going in the right direction. (I know nothing about this and have never experimented with it.)

[RonRay]

Sorry if this has already been addressed by comment or video:

I'm wondering; ... What if you were to use 13 sectors (divisions) in the large disk (rotor), but only use 12 magnets (leaving an unbalanced gap); then, using a fixed central shaft, connect another duplicate setup on the opposite side, with just a slight variation in timing... Would the offset in repulsion be enough to drive it constantly? .... Just a thought.

I am ignorant, but our designs seem to be going in the right direction.

[cheesemuffin94]

What is the engineering application of this I have never seen anything like this before (i am not a professional engineer just a student)

[rufdawg100]

you have done a great job, but your kinetic energy from the wheel needs to be stored and released again like a battery try using a capacitor to store the charge, and release it again back to wheel.

think of a waterfall, water keeps moving but always cycles back from gravitational fields. so you haev the gravitational field but now you require energy to be put back into the system. (Like current from a water). If you understand how nature works, then you understand electricity. this no mystery!

[rufdawg100]

you have done a great job, but your kinetic energy from the wheel needs to be stored and released again like a battery try using a capacitor to store the charge, and release it again back to wheel.

think of a waterfall, water keeps moving but always cycles back from gravitational fields. so you haev the gravitational field but now you require energy to be put back into the system. (Like current from a water). If you understand how nature works, then you understand electricity.

[ExpertOfSound]

Cool!

at 1:24 until it stops spinning, it creates an optical illusion that the magnets are going outwards, because of the way they are positioned :D

[cms1964]

There is a magnetic shielding materialcalled MUMETAL, it is also offered as a folia of 0,1mm thickness. Try to cover those spaces which offer resistance when turning the wheel and it should run for ever!

[cms1964]

There is a magnetic shielding materialcalled MUMETAL, it is also offered as a folia of 0,1mm thickness. Try to cover those spaces which offer resistance when turning the wheel and it should run for ever!