Heat Shrink Holders - Sodick High Speed Mills - High Speed Machining Centers - Video Demo

Shrink-fit tool holders (HSK-E32) are used on the Sodick High Speed Mills/High Speed machining Centers. They are the best method used for HSM with spindles over 30,000rpm.

Category:

Science & Technology

Tags:

• High Speed Mills
• High Speed Machining Centers

[SimpleUser11]

Does the heat changes hardness of the tool? As far as i understand tool should become softer due to higher temperature. Am i wrong?

[SodickUSA]

@SimpleUser11 That's a good question. Typically, heat shrink tool holders are used with carbide end mills which do not seem to change characteristics as they are heated or inserted into a heated tool holder. I say they do not seem to, meaning I have not seen a decrease in tool like due to the use of heat shrink tool holders compared to collet, or hydraulic tool holders. I have used very small, .05 mm drills, in heat shrink tool holders while drilling stainless steel without any problems.

[SodickUSA]

Quick and efficient machining is the main reason for a high speed mill. These machines are capable of milling a wide range of materials from soft to hard, such sa copper and aluminum, or brittle materials such as graphite, glass or even silicon. These machines enable the user to get the job done faster then a 5000 rpm mill.

[SimpleUser11]

@SodickUSA Thnx. What the tempereture required for this operation? And diameters of the tool and inner diameter in the holder?

[dougspair]

@R1K4RD05 ..heat it and pull the tool out..

[dougspair]

@SimpleUser11 .The heat is kept below the critical temperature of the tool holders...

[squiggofant]

@SimpleUser11

Yes, you're wrong.

[R1K4RD05]

how do you remove the tool from the holder?

[hvguy]

That should be an induction heater. COntact resonantpower for further details.

respwrDOTcom