Trailer Wiring Harness Installation - 2003 Dodge Caravan - etrailer.com

http://www.etrailer.com/tv-Wiring-Harness-Install-2003-Dodge-Caravan.aspx

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.

Today at Etrailer.com on this 2003 Dodge Caravan we are going to be installing part number 118376 from Tow Ready. The first thing we are going to do is gain access to our trunk. We are going to need to remove the fascia here and remove a couple of clips so we are able to pull back our panel a little bit to gain access to our wiring harness. We are going to start removing our bumper fascia. We are going to use a rivet tool remover and just popping them up. It is a pretty simple task. If you do not have rivet tool remover you can just take a flat head screwdriver and slide it under and just pry up. That will also work as well. We are just going to take this and set it aside. Then we are going to take the rivet tool remover and start unclipping a couple of clips from here. 00:49

The reason why we pulled this back is because we have to gain access to the hole back here to where we can run our harness through the hole here and out to plug into our tail light harness. Next we are going to remove the driver side tail light. To remove the tail light we just take these plastic rivets and just remove them and the tail light assembly will come out. As you can see our tail light assembly just falls out like that. Now that we have our tail light loose we are going to disconnect it. We are going to take the little red tab and pull it out to where we can disconnect it. We are going to set our tail light aside. 01:49

We are going to take our wiring harness, and as you can see it has got male and female end. We are just going to match them up, plug them in. Then we are going to take our grommet and pull it out. We are going to cut it right here to where we can pull it off for now. We are going to take the rest of our wiring harness and we are going to feed it through the access hole until we get the entire harness inside the sheet metal. We are going to leave the connection point that is going to go back into our tail light out. We are going to take our grommet and put it back on our new connection point and put it back in place. Then we are going to take our tail light and reconnect our tail light and reinstall it on the vehicle. Make sure when connecting it that you push that locking tab over and then take your plastic rivets that we removed earlier and just put those back in position. 03:00

Category:

Autos & Vehicles

Tags:

• etrailer.com
• 118376
• 2003 Dodge Caravan
• 2003
• 03
• Dodge
• Caravan
• wiring
• wiring harness
• install
• installation
• vehicle wiring
• custom fit vehicle wiring
• wiring harness installation
• trailer wiring harness install
• Tow Ready
• 4-pole
• T-One
• T One
• T-1
• T 1
• trailer connector