How to install headlight housing on 91 Honda Accord 1st Part

How to install headlight housing on 91 Honda accord. step by step, bolts and screws, taking off bumper, taking off headlight housing, replacing headlights housing

Category:

Autos & Vehicles

Tags:

• How
• to
• install
• headlight
• housing
• on
• 91
• Honda
• Accord
• Part

[koopa008]

the bumper screws under the headlights can be reached by unclipping the headlight housing glass or plastic that holds it

[snowboarderdude]

I would like to know how you broke the stupid plastic rivets on the bumper. Where you said you were gonna' drill new holes. I would like to see that part.

[koopa008]

@snowboarderdude you have to break the plastic screws IF they dont screw off. If they screw off you can re-use them. about the drilling new holes you dont have to do that, all you have to do is use the same hole the screws were originally placed, you can buy the same bumper screws in any automotive shop, like kragen or napa etc...they're like five bucks and you'll have enough to even replace back bumper if you needed to. at least take a sample of the broken screw so you know what you need

[juanito1347]

Thanks a lot. These videos saved me some money

[yougodit]

@koopa008 Thanks a lot. These videos saved me some money

[coolin7000]

hes tearing that motherfucker up!

[trucker11686]

why would you take the bumper cover off the rebar and then take the rebar off? The whole thing comes off in one piece if you leave the cover on the rebar. You just created so much extra work for yourself.

[thepowderblue212]

ur doing it wrong dumbass

[sneakyfoot23]

if one side was done that would of save time for us to see u put the new ones instead of u going back and forth to each side

[yougodit]

I have a 1990 Honda Accord LX, same body type as your 91. The headlights are over some of the bumper screws. I noticed in this video that your headlights are behind the bumper screws. How did you get the headlights to go behind the bumper screws?

[TheJanko34]

@snowboarderdude You rip out the plastic rivets on the bumper by using needle nose pliers and ripping the crap out of them and then pulling them out. They are suppose to unscrew but probably wont cuz of poor design and age. You can replace them with rivets or clips from loews or home depot. No need to drill new holes.