Land Rover Repair Guide No.1
Loading...
Loading...
4:58
BBC-TopGear LandRoverby theobayona66,882 views- 2:24
1968 Land Rover Series II Aby 1964FordFalcon19648,045 views
- 9:27
Blue Ridge Rover Works Part 1by snakesteve687,824 views
- 1:14
Land Rover repairby FroschmannRehlein14,114 views
- 9:59
My 1965 Series 2a 88" Land Roverby snakesteve6820,584 views
- 7:13
Land Rover 90 - DIFFERENTIAL REPLACEMENTby ActionManuals10,659 views
- 6:50
Land Roverby CAPTAINQUINN7,859 views
- 4:58
Land Rover series 3 restorationby cmaddis529,194 views
- 5:28
classic range rover restorationby owenramsay15,014 views
- 2:29
1959 Land Rover Series IIby LRFV45,805 views
- 9:24
Lucky 8 Ashcroft CDL Install for a Land Rover Discoveryby fivespddisco29,685 views
- 0:33
Land Rover afloatby Kiwirogue16,513 views
- 8:52
my 55 series 1 resto - PART ONEby todesign4life3,417 views
- 1:42
head Gasket repair -- 72 Land Roverby barnfind884,806 views
- 2:32
LAND ROVER CUTTING WOOD AT JAKE WRIGHT,S UK INDEPENDANT LAND ROVER SPECIALISTby JAKEWRIGHTLANDROVERS7,233 views
- 9:35
Land Rover Series 1by todesign4life26,075 views
- 2:01
Rover Repair Guide No.3by MFO9188,386 views
- 9:23
Part 1 of 2 - Land Rover - All in a Day's Workby roverhaul16,477 views
- 0:59
Land Rover Series 3 gearbox selectorsby TropicalSunriseTans10,620 views
I'm no Rambling Hiker. But shouldnt your jeep be a bit quieter?
tommiatkins 3 months ago
ALSO, and probably easiest -- Use 3 12 volt auto batteries wired in series, negative to positive, using 2 short wires and a jumper cable as an arc welder for 3/32 stick, using the pos. side of the circuit as ground which makes a stronger arc. Ordinary arc eye-protection required, #10 filter lens. This will make a surprisingly effective & durable weld-repair.
starmanskye 1 year ago
Hmmkm ... I would have used epoxy or superglue, and THEN wrapped well with duct-tape. After all, it IS a key suspension part. Even better, rewire the shop's main service buss for the buzz-box. OR modify the vehicle's existing generator as a welder. Alternatively, make a forge to use charcoal, melt some scrap steel and hammer-weld repair the part, making it twice as thick. Or cannibalize the mount off one of the rolling-stock parts cars.
starmanskye 1 year ago
why don't you try chewing gum? will much better hold than tape :-)
Froschmaenner 3 years ago
not enough tape. i dont think it will hold.
CAPTAINQUINN 3 years ago
The tape was okay but I think you went a bit overboard with the copperslip.
betyerdid 3 years ago