F350 Dually Trailer Pull

Custom Tamiya F350 Crew Cab body, home made chassis, dual rc4wd front shocks, Tamiya Leaf Springs, rc4wd K44 axles, 1.9 rc4wd rock creeper tires, homemade wheels using Tamiya Semi's and 1.9 HPI, 2 Speed Emaxx tranny under the hood, dual rc4wd 55 turn motors, EVX2 esc, dual 8.4v batteries under the bed, GCM Transfer Case, MIP shaft from tranny to transfer case, axial front shaft, lengthened rear shaft using traxxas shafts

Category:

Autos & Vehicles

Tags:

• F350
• Dually
• Trailer
• Pull
• RC4WD
• Tamiya
• Scale

[videobymark]

Thanks! I would have drove the beetle onto the trailer but it wasn't in running order.

[MrRcaddic]

love the truck

[videobymark]

@MrRcaddic Thanks!

[videobymark]

The front wheels are a bit different, this time you leave the spokes in the HPI wheel, but you cut the face off the front of the semi wheels and glue it on the HPI wheel. Think of it like putting a hub cap on a rim. You have to do this because the front Semi wheels don’t use a 12mm drive hex.

[videobymark]

To make the dually wheels you start by cutting out the spokes of the HPI wheel, clean the cuts so they are smooth so you end up with just the outer hoop of the wheel, then you simply press the semi wheel inside of it. It presses in nice and tight, after you get the spacing you want, glue it on the back side of the rim so you don’t see any glue.

[videobymark]

lol thanks



[simonz28]

9.5 out of 10 .. if the beetle was going at the start , ( perfect location for sand scorcher )

then got put on the trailer , you would have got a 10..

one of the better duallies getting around.. cudos

[MrRcaddic]

nice truck dude

[drewdogg1972]

nice truck.....nice color.....nice trailer....

[puncher25]

Travis!  Didn't you see his post, "I'll never make another one!"?? LOL

[SouthTXfish]

Can you show how you made the semi rims and HPI rims work together?