Joe Gibbs Performance Silverado Dyno Run

2005 Joe Gibbs Silverado Dyno run.

334.74 Rear wheel horse power @ 5850 RPM

336.40 foot pounds of Torque @4000 RPM
with 5 PSI of boost.

AND IT HAD SO MUCH MORE, damn rev limiters! Damn them all to hell!

Category:

Autos & Vehicles

Tags:

• Joe
• Gibbs
• Performance
• Silverado
• 2005

[zr2chevypickupman]

so what are your thoughts on those programmers such as edge evolution programmers? are they any good or are their any better kind that let you change all your settings without having a big controller like the hypertech tunners

[Pilwho21]

I really haven't had to much interaction with programmers. The only one I have worked with is the Hyper tech programmer that came stock with the JGP Silverado for use strictly with the Magnuson supercharger. I really couldn't tell you to much about them.

[fmscott2009]

pilwho, i have a 2006 z71 tahoe will this kit work for my vehicle thanks for your time

[Pilwho21]

It should work, if you have the 5.3L you can get the supercharger through Magnuson Superchargers runs about six thousand. Everything else will fit I.E. the front fascia, rims and badging. But the key is trying to find it all, VERY hard to get all the exterior body parts. They are all out of production now, Ebay had been the only place I've seen the parts. I've only seen the front fascia show up 2-3 times over two years.

[jh714c]

where did you get the front bumper from?

[Pilwho21]

Thats a stock vehicle from Joe Gibbs Performance. They install it and sell the truck through Chevy. The design was originally from Decoma. I havent personally found it anywhere else but on the Joe Gibbs vehicles

[Pilwho21]

New dyno pull just done

352.58 RWHP up from 334.74 RWHP 17.84 HP gain

383.87 RWTQ up from 336.26 RWTQ 47.61 TQ gain

Add on's included smaller supercharger pulley, JBA shorty headers, MSD super conductor wires, ACdelco iridium spark plugs and Yukon posi-unit

[jvera707]

im thinkin bout goin a lil higher.... i got headers put on

[Pilwho21]

I think im going to stick with that pulley, I dont want to go any higher on my boost with out changing any internals

[jvera707]

yea thats what i have right now....im going to get the same done to mine in a couple of weeks....right on bro