Show bearings spin using graphite on a dry bearing
Loading...
Loading...
988
views
Link to this comment:
Share to:
Uploader Comments (Magluvin)
Video Responses
This video is a response to Free Wheeling Bearings for Pulse Motors
Loading...
- 1:533d Simulation Magnet Motorby zeropointfuel104,251 views
Featured Video
- 6:47Best Bearing Spin......... Everby aripowell235,665 views
- 2:19My $3 Homemade Longboard / Shlongboardby TheClemsonDude81,866 views
- 1:52No Bearing Bedini Motor IIIby Pirate88179776 views
- 2:49EDM Graphite Material Selection.aviby OhioCarbonBlank225 views
- 1:57Powdered Graphite Added to Freewheeling Bearingsby introvertebrate1,671 views
- 3:03How to Power Your Car Using Magnets - HacknMod.comby Joe11115595,908 views
- 2:15Free Energy - Selfrunning Bedini Motor Replicationby bedinireplication396,922 views
- 3:21Fun with Magnetsby wjbombo66,833 views
- 0:42Lutec Electric motor 500% percent efficientby freeenergy4everyone15,293 views
- 3:38An interesting approachby furzeham317,078 views
- 3:41LTD Stirling Engineby imajeenyus425,765 views
- 6:50Tesla Pancake Coilby camster6125,275 views
- 1:12Tesla Turbineby FireHazard101494,145 views
- 3:04Graphite-paper Aluminium foil battery cell brea...by overunitydotcom4,050 views
- 0:24One magnet no bearing Bedini motor.Magnetic cog...by jonnydavro6,533 views
- 1:14bearing spin.wmvby gonbay084112 views
- 0:56Magnet motor low rpm lockby Magluvin463,827 views
- 8:04Back emf currents seem to be high from these bi...by Magluvin795 views
- 0:51Abec 7 bearing spinby theARMONexchange20,405 views
how do you apply the graphite ?
florinnichifiriuc 2 years ago
Remove the seals. Heat up the bearing to about 150 deg to loosen up the grease some. I use acetone to soak them. Then blow them out with air. Soak again. Then use WD40 heavily. Blow out and soak in acetone and blow out till dry.
The grease tends to reside in the bearing cage, this should remove just about all of it. Then apply some graphite powder in the bearing. I used an aluminum shaft in my cordless drill that fit the inside the inner race and held the outer race by hand to wok it in.......
Magluvin 2 years ago
....Apply pressure by hand to work the graphite in for a few min. then blow out excess. Apply more graphite and work again and blow out again. Some bearings once dry are tight, even from the same lot, and they may not get any looser with the graphite. If that is the case, try another that is a bit loose and you will have a winner. After it may sound a bit gritty but will run like a charm. =]
Magluvin
Magluvin 2 years ago
thank you for the quick answer
florinnichifiriuc 2 years ago
Yer welcome
Mags
Magluvin 2 years ago
Amazing... will give it a go!
introvertebrate 2 years ago
And it will go and go and go. =]
Magluvin
Magluvin 2 years ago