A DIY home made balsa rc plane part 3 of 6 scratch built

cheap simple home made DIY scratch built balsa wood epp corriboard first proper flight and gliding test of 2010 on board video

Category:

Entertainment

Tags:

• cheap
• simple
• brushless
• motor
• DIY
• rc
• plane
• home
• quick
• build
• aeroplane
• with
• no
• plans
• from
• balsa
• wood
• epp
• corriboard
• corroplast
• coroplast
• coro
• on
• board
• key
• fob
• covert
• mini
• digital
• spy
• cam
• video
• camera
• r2
• hobbies
• turborix
• six
• ch
• tx
• rx
• channel
• radio
• reciever
• remote
• control
• transmitter
• Ireland
• 2010
• homebuilt
• homebuild
• homemade
• balsawood
• made
• first
• proper
• flight
• and
• gliding
• test
• scratch
• built
• rcplane

[tadflip]

its really cool, but i think a view from the front would be better so its like youre actually in the plane

[michaelrc1]

@tadflip Thank you for your comment  .I must see if I still have this plane and give it a fly . This video is part of a six series and the last one has the camera facing forward

[cotoclop]

Ups beep? Lack off electricity?

[michaelrc1]

@cotoclop Thank you for your comment . Are you commenting on the beeping the plane is making or the power lines that are in close proximity to where I fly

[tadflip]

@michaelrc1 ok i will watch that one

[michaelrc1]

@rich202100 My tip would be to keep every thing as light as possible and if you could get a radian glider wing as the wing is the hardest to make also when you have built your plane go to a field with long grass and launch it with no power into the wind and if every thing is ok it should settle to the ground nicely. Any other questions fell free to ask .

[michaelrc1]

@rich202100 As it is balsa wood any paint can be used . I used a spray paint

[michaelrc1]

The power system I later found works best for this plane is as follows . Brushless outrunner motor BL2217/11 950KV . 30 amp ESC with programming card . Propeller 10*6 folding . 11.1v 1200mah 20c lipo . 4*9 gram servos

[michaelrc1]

Materials for this plane are as folows Two pieces of balsa 1000*100*8mm Corriboard 2mm for tail 3mm for wing epp to fill wing profile and a block of epp for motor mount servo rods and connectors

[michaelrc1]

@ChRiSNXT This plane is fairly easy to make . I have since put a more powerfull motor and bigger prop for flying in windy condtions which works realy well . This is an on going project . Hope to make more videos from this plane soon