Video #16 - Hook-up Location For HHO To Engine.

Here's where the HHO input hose is hooked up to entering the manifold on a 2001 Ford Escape.

Category:

Science & Technology

Tags:

• meyers
• cell
• hydrogen
• booster
• water
• car
• fuel

[wesjp]

Hello guys I have located the signal wire for the MAF enhancer.... On the MAF plug its the second wire from the left...I installed my MAF enhancer and lean it out to aroung 16GPH..The MPG on flat road at 55 MPH held steady at around 42.5 MPG..Smiling Now :)

[kevlauenterprises]

What color wire is it?

[wesjp]

If you look at this video at 0:17 that is your MAF...

[kevlauenterprises]

I think I see where it is - I'll check it tomorrow. Did you run a line somewhere into that or near it? You can e-mail photos to info@kevlau(dot)com.

[wesjp]

Hello again. I haft to post some new info...I recently placed the hho output tube into the air filter box and ran a tube close to the MAF with the scan gauge before i was using 0.26 GPH at idle...now its at 0.13 GPH with the new location... figured id pass this on. This was done on a 2003 escape.. 2.0 liter.

[kevlauenterprises]

You have to give me some more info. on where this is located so I can try it. Where is the MAF???

[RockBandJosh]

what about test results?

what kind of mileage are you getting?

MAF sensor enhancer?

[wesjp]

The color is Light blue...Small purple stripe..

[wesjp]

That info was on a 2003 Ford Escape 2.0 liter...

[wesjp]

In responce to Lukeoid. On the escape where the spare tire is the rear....there is a rubber knockout in front of the bumber..this will allow you to route your hose..I can send yah some pics if yah need them...

[lukeoid153]

Hello,

How did you connect/route your tubing under the frame, in how did you mount your cell in the back. Any hints on how to do it properly?

Thanks for your vids and hard work!

[wesjp]

The MAF sensor is right after the air filter box. If you have an email ill take some pics and show you exactly where I put it.