Sizing the Cast Bullet Part 2
Loading...
Loading...
26,374
Loading...
Uploader Comments (ammosmith)
see all
All Comments (22)
-
@ammosmith Just shooting the same loading for my revolver out of a longer rifle length barrel will get an extra 200-400fps. Is there a change in mix of the bullet or lube that would make it any less of a leading or safety problem? Or do I just need to go to gas checks or jacketed bullets? Or decrease the charge? Thanks.
-
@spritrocks Check what the OAL should be for the Marlin. You have some latitude on seating depth.
-
Thanks ammosmith I was thinking about buying the 300 grain swc mold from Lyman but not sure if it would cycle thru my marlin lever action in 44 mag
-
I'll spray them win WD40 and store in a steel ammo can. Then I'll decrease it with acetone or boil I in soapy water then cast again.
Loading...
4:31
Stupid people doing stupid thingsby GaloreVideos7,462,861 views- 6:13
Sizing the Cast Bullet Part 1by ammosmith26,314 views
- 1:14
gun safety gone wrongby DNICK122398,863 views
- 2:36
Home made ball moldby spudgunner7319,266 views
- 10:28
Lubing and sizing bullets - Part 3 Lubrisizing bullets.movby duelist19543,331 views
- 2:32
bullet puller trickby Rokn46023,240 views
- 7:57
Excessive Pressure Indicatorsby ammosmith63,307 views
- 9:47
Smelting wheel weights into ingots for bullet makingby daywalker62736,340 views
- 1:27
Casting Softnose Bullets Conclusionby ammosmith9,453 views
- 2:14
Smelting Wheel Weights Into Ingots Pt.#3by spinesales7,225 views
- 6:09
Primers What You Need to Know in HDby ammosmith66,705 views
- 0:40
Star lube sizer with a motorby sunline243,929 views
- 6:34
Cast Rifle Bullets Part 1by ammosmith21,686 views
- 14:22
Barrel Making at Pedersoli factoryby capandball23,143 views
- 5:53
Cast Rifle Bullets Part 2by ammosmith9,200 views
- 9:43
Casting Lead Bullets Part 3by Tacticalreview26,047 views
- 4:36
Making Hollow Points With a Case Trimmerby ammosmith85,166 views
- 3:58
Lee Factory Crimp Die.by ammosmith57,435 views
- 5:05
alox1.AVIby skelly60717,639 views
In this and your other videos you say your getting 1500fps out of your 10in barrel with is 240gr Lyman 429421 bullet without leading with your lube. If I were to get another 300-400fps from a 20in Marlin rifle barrel, would I get leading in your opinion. Would you change the lube mixture? How? Any other recommendations? Thanks.
300UMLRH 4 months ago
@300UMLRH Might get a stuck bullet....be careful
ammosmith 4 months ago
Thats wat I will do thanks ammosmith u never fail to help me out
spritrocks 10 months ago
@spritrocks No...thank you for watching!
ammosmith 10 months ago
Would seating the bullet deeper cause more pressure?I heard some semi-wad cutters won't cycle as good in lever guns
spritrocks 10 months ago
@spritrocks Yes pressure does go up so you'll need to reduce the load and work up again. See if you can get a slug and make a dummy so you can action proof test it.
ammosmith 10 months ago