How to Install a Can Light
Loading...
Loading...
4:48
Recessed Lighting and Flush Light Installationby ElectricalContractor77,857 views- 0:45
Adding more recessed lightsby Generation3electric7,987 views
- 2:13
How to see through clothingby WilliamRayWalters27,811,090 views
- 2:08
Wiring of Recessed lighting over Ceiling and Under Cabinet.flvby randlerkriss25,819 views
- 8:04
Cooper HALO How to Install Recessed Lighting in Engineered and Laminated Lumber New or Old Constructionby FrostPowerTools15,188 views
- 1:23
Recessed Lighting remodel made easyby s2000pill13,015 views
- 4:18
How to Install the EcoSmart LED Downlightby CreeInc15,644 views
- 2:56
Turn It On! How To Change A Light Fixtureby HotandHandyShow31,026 views
- 2:09
How To Run Cable Inside a Wall with Insulation Videoby DiscountLowVoltage61,057 views
- 1:16
Recessed Lighting-DIYby DIYNetwork6,036 views
- 4:46
How to Install Recessed Lightingby SkilPowerTools38,639 views
- 2:42
Ceiling recessed light installationby RONAinc9,185 views
- 2:17
How To Install EcoSmart LED Downlightsby FrontStepsMediaLLC19,993 views
- 1:42
How to Install Recessed Lighting - Introduction to Recessed Lighting - Pt 2by LBCLIGHTING113,331 views
- 2:40
A Common Goof Replacing Outletsby TheCircuitDetective71,295 views
- 0:06
Special Talentby NerdOnTheNet5,912,684 views
- 3:02
10 Tips for Fishing Wire From the Atticby wire2usite23,500 views
- 2:33
How to Install Recessed Lighting - Introduction to Recessed Lighting - Pt 1by LBCLIGHTING151,628 views
- 1:00
Watch this similarity ! ! !by fredpilud5,557,657 views
Hello Ryan Good job
prichfred 1 month ago
The "yellow colored wire" is romex consisting of (1) hot, (1) neutral, (1) ground wrapped into one sheathed assembly. The yellow wire you see comes from the switch on the wall. In most cases where remodeling is occurring a wire may be present at location of light. If no wire is present one will need to be added. Thank you.
RMaresch35 2 months ago
Ok, so how do you reach the yellow wire? How can you be sure it's right there after drilling the hole?
minott6 2 months ago
Stupid fitting!!
RonanM101 4 months ago
Sure!
RMaresch35 7 months ago
@RMaresch35 Thanks for the info man.
higgout 8 months ago
@higgout Yes you are able to set a box in the attic and feed (6) can lights, provided your box fill capacity is within NEC limits. Another method is to use the box on the side of the can lights as a junction box. Then install existing romex into can-light-junction-box that formerly fed fluorescent light. Daisy chain from your first can light, ( install one romex in, and one romex out) to your next can light and so on. Each can light will then have (2) sets of romex (NM Cable) one in and one out.
RMaresch35 8 months ago
Nice and detail. My question is if I have a double 4ft flourescent in my kitchen and want to put in six 4" recess lights instead can i just put a box in the attic where the wire for the flourescent feed is and then tap six lead off of it to feed each light?
higgout 8 months ago
Correct, I hated to skip such a vital component however, the videographer was charging. Thanks for watching
RMaresch35 9 months ago
hey, what about that connector that is required to hold the wire onto the can that I noticed you forgot to use ???
radarmd27 9 months ago