2007 Mustang GT Dyno Pull

My 2007 GT Dyno Run after modifications at 1,600 miles, Mobile 1, 4:10, Delete Plates, Underdrive Pulleys, CAI, Dyno Tune 93 oct., Offroad X-Pipe, Cams, head work 367hp 336 Torque @ 99 Degrees Garage Temp. at the rear wheels

Category:

Autos & Vehicles

Tags:

• 2007
• Mustang
• Dyno

[TN2007GT]

Best time 12.83 @108 spinning in second & third with bad wheel hop in both. Added Steeda Lower & upper control arms. Can't wait to get back on the track this spring. Steeda arms cured the wheel hop. Also put on Steeda aluminum drive shaft. That gave me us much improvement as the cams. If I had it to do over, forget the cams spend the money on the driveshaft and the delete plates, both will give you more than the cams.I got right at a two tenths improvement in et just with the steeda driveshaft.

[mustangt07red]

thats amazing...... really like it dude.

[skastershane]

nice stang i just upgraded from a 02 v6 stang to a 07 gt :) what do you say was the biggest power gain youve done

[aaronbigtime]

whats the 1/4 mile on this car? about to do the delete plates and udp next is cam to my 06

--

Sent from my Helio Ocean

[preludeboy9500]

what kind of cams? what kind of head work? any valves?

I'm about to do heads/cams on my 06.. looking for ideas.. 367hp at the wheels is pretty good