2004 Mustang V6 MP90 Gen IV Eaton Supercharger 0-??? run

'04 Mustang V6 that I built a Eaton supercharger setup for. This run is from a standing start up to ???. There is more left in it if I can ever get the tune right.
2004 Mustang, 3.9 V6, 5 spd, MP90 Eaton Supercharger, 03-04 Cobra throttle body and inlet, 39 lb injectors, 90mm MAF, custom built intake manifold adapter, custom CAI.

Category:

Autos & Vehicles

Tags:

• mustang
• V6
• Eaton
• supercharger
• MP90

[Ltngdrvr]

Supercharger setup is for sale on ebay ebay.com/ebaymotors/ws/eBayISA­PI.dll?ViewItem&item=120647746­943&ssPageName=STRK:MESELX:IT

[seansskyline]

don't you think 7psi is basically in the shitter with that... stock 3.8's can hold 8psi no problme and 10 psi would still be a safe call...

[Ltngdrvr]

@seansskyline 7 psi on a non-intercooled eaton is not "in the shitter" it is a good amount of boost and makes pretty good power. Plus, with the pulley combo's that were available to me, the stock lower pulley or a 25% underdrive, it was either 7 psi or 11 psi. The pulley on the blower is not easily changed, you have to pull the snout to do it on this one, it doesn't have a threaded hole on the shaft to be able to use the puller/installer like a Ford factory eaton has.

[Ltngdrvr]

haven't dyno'd it yet, no funds currently, will get it done eventually.

[Blownpony01]

@shoutingback09 thanks i know this i used to own a v6 mustang, decent cars

[shoutingback09]

@Blownpony01 Only the later half of 04 had the 3.9, first half was still 3.8

[Ltngdrvr]

It is an Eaton supercharger. Magnuson casts the cases on aftermarket units and Eaton makes the rotor pack. The only superchargers that are all Eaton built are the OEM superchargers that came from the factory on the car or truck.

[alensvsix]

God how I cant await to hear it in person!

[TheMrhoneycutt]

@brightsun11 Its a Mangnuson not an Eaton.

[imreloadin2]

what numbers are you putting down?