OKUMA LT 15M (6) AXIS CNC TURNING CENTER

INSTALLED NEW...... 1997

TURNING DIAMETER.............................................. 10.27"
TURNING LENGTH................................................ 30"
DISTANCE BETWEEN CENTERS...................................... 40"
TRAVELS (X1).................................................. 7.56" (C1).................................................. FULL C (X2).................................................. 7.56" (Z1).................................................. 27.56" (Z2).................................................. 27.56" (W)................................................... 28.74"
RAPIDS (X).................................................... 1181 IPM (Z).................................................... 1574 (W).................................................... 1260
SPINDLE SPEED (EACH SPINDLE).................................. 45 - 4500 RPM
SPINDLE BORE.................................................. 3.15"
BAR CAPACITY.................................................. 2.65"
SPINDLE FEED RATES............................................ 200 IPM
DRIVE MOTOR................................................... 20/15 HP
INDEX INCREMENT............................................... 0.001 DEGREE
TURRETS (UPPER/LOWER)......................................... 12/12 STATIONS
ROTARY TOOLS.................................................. 5.4 HP
SPINDLE RPM................................................... 6000

EQUIPPED WITH:

OSP 7000L CNC CONTROL
(2) 10" CHUCKS
HIGH PRESSURE COOLANT
LNS 12' HYDROBAR BAR FEED
8-10 LIVE HOLDERS
STANDARD TOOLING
AUTO PARTS CATCHER
BIG BORE OPTION
CHIP CONVEYOR
SYNCHRONOUS TAPPING
CYCLE TIME REDUCTION, DNC-A, LOAD MONITOR, MAC MAN
COORDINATE CONVERSION

Category:

Autos & Vehicles

Tags:

• Okuma
• LT10
• CNC
• Turning
• Gosiger
• Lathe

[nguerzon]

okuma lt15m with bar feeder... where's the part catcher??? the tool eye???

i operate this one!