Homemade Bullet Feeder Collator (Step 2) The Bullet Flipper

This is step 2 of the collator for my Homemade Bullet Feeder. The Collator feeds the bullets down a tube nose first and this device will flip them over so the hollow base is pointing down as they enter the actual bullet Feeder.

Category:

Science & Technology

Tags:

• Bullet Feeder
• Bullet Collator
• Dillon XL650

[scheibie]

how do you have this set up what is the circuitry is it a 12 volt system

[HBRdesigns]

@scheibie Yes everything is run of 12 volts.

[smaj100]

What are you using for a bullet feed die? Where did you get it?

[HBRdesigns]

@smaj100 Everything on this setup is home made including the Feeder Die.

[fldeerhunter]

I am thinking of building a similar design on the collator and bullet flipper. I have built a small bullet collator but ran into the bullet flipping issue. I think I am going to rebuild my entire design and was wondering if you could share some info with me on your design.

[HBRdesigns]

Just drop me a personal message and I'll try to help you anyway I can.

[musicmaneman38]

How did you wire up the infrared emitter and detector? What circuit did you use?

[HBRdesigns]

That one is a 5 RPM Geared Motor (DCM-276)

[louisyoung75]

what motor did you use for the collator?

[HBRdesigns]

The Motor used on the Flipper is a 6 RPM Gearhead Motor from All Electronics (DCM-245) It's a little bulky sticking out the back and louder than the one I used on the Collator but was all I could find at the time.