How to program JET III M

This video will show you how to program the various modes available on the JET III M. These settings are also used for the M1 X as it uses the same interface for programming. In the program menu, variable brightness modes can be set,SOS 50% and 100%,Strobe and beacon mode.

Category:

Howto & Style

Tags:

• Jetbeam
• South
• Africa

[chriscj101]

Hi Yiarnos, Turn the unit onto the strobe mode. Click the unit off. Lightly depress the tailcap in twice within one second ( as you would for programming in the video). The unit will begin a ramp up sequence from low to highest brightness. Click the torch off at any preferred light setting. Wait at least 5 seconds for the torch to remember this setting. When you click the torch on again, it will be at the setting you programmed.

Hope this helps.

[YIARNOS]

I have the same torch but can you explain further how do i stop the strobe happening and how i can reset to default?