Dc Generator

Check us out at http://www.tutorvista.com//videos
Simple direct current (DC) generators contain an armature (or rotor), a commutator, brushes, and a field winding. The interactive tutorial presented below examines the operation of a simple DC or direct current generator.

Translate the slider back and forth to adjust the frequency of the current.
Note that the voltage amplitude increases with frequency.
A variety of sources can supply mechanical energy to the DC generator to turn its armatures in order for its coils to cut through the lines of force in a magnetic field. These sources include steam, wind, a waterfall, or even an electric motor.
In a direct current generator, the commutator's job is to change the alternating current (AC), which flows into its armature, into direct current. To put it another way, commutators keep the current flowing in one direction instead of back and forth. They accomplish this task by keeping the polarity of the brushes stationed on the outside of the generator positive. The commutator is made up of copper segments, with a pair (of segments) for every armature coil being insulated from all the others.
The stationary brushes, which are graphite connectors on the generator, form contact with opposite parts of the commutator. As the armature coil turns, it cuts across the magnetic field, and current is induced. At the first half turn of the armature coil (clockwise direction), the contacts between communicator and brushes are reversed. The first brush now contacts the opposite segment that it was touching during the first half turn, while the second brush contacts the segment opposite the one it touched during the first half turn. By doing this, the brushes keep current going on one direction, and deliver it to and from its destination.
When a DC generator contains only a single coil, it provides a pulsating dc output. Therefore, scientists use a number of coils to produce a more stable output.

Category:

Education

Tags:

• Dc
• Generator

[momikhan17]

@PathikRaval u r ri8...here it z split rings

[allthingsepic7]

It would not let me slide the slider :(

[allthingsepic7]

poopy

[thekirannalini]

slip rings are diffrernt from split rings or commutator bars....which gives pulsating dc current....

[MiKExAUS]

split rings not slip rings...first tutor vista video i've watched with a mistake

[EdwBagus]

Not a very comprehensive explanation. How many turns of the stator coil required, armature (rotor) required to generate certain voltage/amps as measurements for generator output/capacity. Than you anyway !!!

[iRobii]

thats a ac generator

[maaamn1]

ya he said slip rings and slip rings are shown and the output is dc hahaha no split rings(commutator)

[hossamrida]

@PathikRaval I believe you confused between both :) what is showing here is correct because it uses a commutator, if you are using 2 split rings instead then you get an ac current

Hope this kinda helps