2003 Honda Accord i4 Dyno Runs

My 2003 Honda Accord i4 sedan with numerous engine mods getting three basic pulls on the dyno at Ocean State Performance in North Kingstown, Rhode Island.

Category:

Autos & Vehicles

Tags:

• honda
• accord
• 2003
• i4
• dyno
• dynamometer
• md-1750de
• engine
• cm5
• cm6
• cm7
• cm8
• pulls
• horse
• power
• torque
• ocean
• state
• performance

[graphite81]

How much was the custom cat-back exhaust? I'm looking to doit on my 2007 2dr 4cyl.

[striktlyaccord]

@graphite81 If I remember correctly, pipes, resonator, and labor were about $300. I bought the muffler separately for $190 at the time. I only went custom because there were no bolt-on systems available for my application. You can go custom as well, but there might also be bolt-on systems available for your car since it's an '07 and a coupe.

[DVcustomZ]

If you mention your engine fluids, radiator cap, and battery you need to spend more money

[striktlyaccord]

@DVcustomZ Not quite. It's good to mention even minor details when you hit up a dyno so that the car's setup is fully understood.

[striktlyaccord]

@striktlyaccord Well, I went to another dyno last week, and for some reason I got 10hp less on average than the dyno pulls in the video from 2 1/2 years ago. Very disappointing.

[striktlyaccord]

@xxnissansilviaxx If I remember correctly, the 3 dyno pulls were $75.

[striktlyaccord]

@bubuh456 I think 200hp at the engine may be a little on the high side.

[striktlyaccord]

@hdksb2 We shall see. I'm getting dyno'd again soon.

[xxnissansilviaxx]

what did it cost to do this?

[bubuh456]

i say you have at least 200+ bhp not any less... so that's really good based on the stock 160 bhp.