New capacitor 70Circuit

No more switching back and forth beatvine terminals!
Only a high voltage low current spark needed to trigger the circuit.
Also it looks like that water and gasoline are generating a same amount of pressure when they ignited with these plasma arc on atmospheric pressures!
The circuit designed by capacitor70 and can be find here:
http://cid-a4a1d6e4bb17a7e3.skydrive.live.com/self.aspx/Public/Water%20Fuel/C...

Category:

Education

Tags:

• water
• plasma
• arc
• fuel
• capacitor70

[IndianaBoys]

tiltfulll,

Good work! Give this a whirl. Make a solution of colloidal copper as your electrolyte using simple electrolysis and distilled water.

Get a foot of number 12 copper wire and remove the plastic coating and make your electrodes from that. This is a high enough grade of copper to perform this experiment. In no way are colloids of this grade of copper fit for human consumption, in other words do not drink.

IndianaBoys

[tiltfulll]

Why would I make colloidal copper solution??

[tiltfulll]

Looks like I cant post links here!:(

So I going to put at the description of the video!

[tiltfulll]

Yesterday my diodes vent south! I ordered some new ones! But then I saw capacitor70-s newest circuit. No diodes! Also before the diodes dyed I put a different plug on the circuit. A plug with no ground electrode! I broke at off, than send it flat. I was getting so loud bangs that I had to wear ear protection!Even in dry condition! When it was wet it shoot that plastic cap against the ceiling than bounced back down the floor than up again! High speed! Here is his new circuit!

[tiltfulll]

A have put a link in the description of the video!

It's going to take you guys to the diagram!:)

Be safe!

Think twice before you touch something on the circuit!

[swollwerth]

Is the high output positive of the ignition coil going to the + of the spark plug as in other demonstrations?

[tiltfulll]

yes

[FlavoredCoffeeGuy]

This is known physics. It's working just like a xenon flash bulb. The sparkplug coil is not helping. About 400 Volts in a couple of large capacitors will do more, with the diodes. You don't need the spark plug coil at all, if you continue to use the igniter. A solid state circuit would use the spark plug coil instead of the igniter.  You just need to protect the capacitors from the high voltage. I'll send you a link to the kit.

[IndianaBoys]

Blast improvement. Some are using tap water that has calcium and magnesium in the water. If someone has a water softener and uses tap water, they are basically using salt in their water. There are many different electrolyte solutions that could be tested. With the conductivity of water, it should provide for an improvement.

[capacitor70]

More the gap stronger the blast. With small gap it works like normal spark.

[capacitor70]

Thanks for sharing results and observation .

[dreamyear]

High current can kill you...scary.

I use glove