Cool Care 5inONE clipper spray - How to use - Ivan Zoot - Tool tips - 1206
Loading...
Loading...
2,810
Loading...
- 11:30
Sir Reginald presents the temple taperby Sirreg5714,954 views
- 1:23
Clipper Oil - How to - Ivan Zoot - Tool tipsby andisonvideo7,575 views
- 12:16
disinfecting clipper blades,how to clean barber clippersby topofthelinebarbersh3,731 views
- 3:28
KLIPPERS BARBERSHOPSby amorimd060928,686 views
- 4:28
Andis Nano-Silver Magnetic (Guards) Comb Setby alsmillions16,445 views
- 1:55
Andis Styliner II - How to adjust the bladeby andisonvideo20,978 views
- 5:05
Wahl Detailer vs Andis Superliner Reviewby ByBarbers4Barbers9,704 views
- 2:34
Acuttabove - Best Barber Clippers to useby 2XAllState106,972 views
- 1:44
Andis experience gtx T-Out liner UNBOXINGby Finelinesbarber73,890 views
- 3:57
MVP clipper and NEW Andis blades - 216by andisonvideo10,407 views
- 3:14
Clipper Guy (Ivan Zoot) performing Panel Cutting technique at A.I.B..MPGby TheAIBschool2,457 views
- 6:29
How to fade hair - Andis Tool Tips - 1201by andisonvideo66,896 views
- 1:58
left and right ear area taper guards - Ivan Zoot - Andis tool tips - 803by andisonvideo8,138 views
- 3:43
The Superliner is Realby Profilecorp9,878 views
- 8:34
how to cut hair clipper over comb - andis tool tips - ivan zoot - 704by andisonvideo8,692 views
- 0:00
SuperLiner - Andis Tool Tips - Ivan Zoot -NEW - 404by andisonvideo15,995 views
- 4:03
how to taper cut hair - Skip Guard Tapering, great taper technique, Ivan Zoot - 502by clipperguysays80,211 views
- 2:57
Andis / Ivan Zoot Tool Tips - Meet The SpeedMaster - 504by clipperguysays12,714 views
- 7:35
line up edge up how to hair cut trim andis ivan zootby andisonvideo2,996 views
yes... thin film of oil prevents rust when not in use, too. Ivan
andisonvideo in reply to knocknout (Show the comment) 5 months ago
had a question i just the clippers but im the only 1 that use it im not a barber but do i still need to get the oil its only going to be used about 2 times a week for a couple of mins..........
knocknout 6 months ago
if the tool is a rotary motor... better for it to be off... if the tool is VERY hot... better to be unplugged. Pioint the tool to the floor so excess liq drips on floor not in housing.
Ivan
andisonvideo in reply to emanuscriptgraphics (Show the comment) 1 year ago
So I was told the clipper needs to be off, this is incorrect info?
emanuscriptgraphics 1 year ago