Part 13 Build a Putt PuttPop Pop Steam Boat s10glue

Part 13 is Step 10, is actually gluing the aluminum so it keeps its new shape. You should watch the whole step before starting because you only have 5 minutes once you mix the two parts together (less if it's hot). You should have equal parts and mix thoroughly. Dab it on the silver parts even where the silver disappears, especially the ends. It's really important to push the epoxy in between the folds of aluminum with the strip, for strength and to prevent leaks. NEW, NOT IN THE VIDEO: THANKS TO JIM WYNHOFF AND OTHERS FOR THE TIP THAT YOU CAN CLEAN UP STICKY EPOXY WITH VINIGAR!

You can find more DIY science projects like this at http://www.sciencetoymaker.org/

Category:

Science & Technology

Tags:

• pop pop
• putt putt
• steam engine
• boat
• build
• make
• science project

[whatalamenameaviotss]

can i use super glue? the one that you dont need to mix

[sciencetoymaker]

@whatalamenameaviotss No, super glue does not seal, bridge gaps.

Slater

[AusOiPaul]

CAn i solder it instead cause i'm lazy

[sciencetoymaker]

@AusOiPaul Solder does not stick to aluminum

[oo7101]

Can you use standard white glue?

[sciencetoymaker]

@oo7101 No, it has to be waterproof

[AusOiPaul]

@sciencetoymaker yeah i kinda realise when i did it and it melted the straws but thx for the advice anyways :D

[sciencetoymaker]

@CrismarkRock no, that part gets hot, it would melt

[CrismarkRock]

can i use hot melted glue instead of epoxy glue?

[sciencetoymaker]

@Raymond37733 If you have a very good engine and there is no wind, a tea candle can work, but it's slower. I used to use epoxy, then silicone for leaks, but now I just use epoxy.

Slater