Atomic Warhead buggy maintainence part 3 - Clutch
Loading...
Loading...
14,800
Link to this comment:
Share to:
Uploader Comments (andyandvirg)
see all
All Comments (30)
-
@Blkmike1 you have melted you clutch to your clutch bell
-
@andyandvirg Righto thank heaps for the help mate
-
im having problems with my warhead, i broke it in and everything but i turned it off and let it cool down a bit. then when i tried to start it again the big cog behind the clutch just spins when i pull the starter, any ideas?
-
hi when i start my buggy all i can do is rev it and the wheels wont spin do i need 2 by new clutch shoes
Loading...
- 3:48Poly pipe land yacht 2012by andyandvirg8 views
- 0:28Clipsal 500 by 7yo Williamby andyandvirg85 views
- 1:17Azor Dutch bicycleby andyandvirg114 views
- 1:11Symonds Channelby andyandvirg69 views
- 7:16How to replace 3 Piece Clutch Shoesby alishanmao8,506 views
- 6:39HSP Warhead 2nd tank run inby MrPCPerformance4,661 views
- 1:59HSP Atomic Warhead Modifiedby bettabgood95,931 views
- 2:02Atomic Warhead high speed testby xxxxmickyxxxx23,842 views
- 1:19HPI savageby dabombcreator8,751 views
- 3:45China Hiding 3000 Underground Nuclear Warheadsby ChinaForbiddenNews5,398 views
- 7:47atomic warhead at bmx tracksby jdevo54913,764 views
- 0:53revving my rc car with no clutch bell or clutchby HolyFxxxIplayHalo216,822 views
- 0:55Fallout 3 Nuclear Warhead Launcherby DRESSINGP407,454 views
- 0:31backwash buggyby digitalneil4,792 views
- 16:183-shoe Clutch Installationby RCDriverMagazine6,643 views
- 9:36Mantenimiento de amortiguadoresby hablamosdetodo58,872 views
- 1:59My Atomic Warhead Rc Carby jeko0965,869 views
- 5:23FASTEST CAR 1:10 NITRO BUGGY YETby cybernutcase147,079 views
- 2:17HSP Warhead a Short maiden runby jthornley123,947 views
- 4:56Revenge of the Warhead!by louncov1,010 views
i have the same problem as 777randomman, is this just the gears not meshing properly? and also can you over tighten the engine so as the gears mesh too much? please reply ASAP i wanna drive again!!
LittleGreenMen0 7 months ago
@LittleGreenMen0 It could be the gears not meshing or a missing drive shaft. To mesh the gears just loosen the 4 screws holding the motor and slide it in a bit so the gears mesh, then tighten the motor screws again. I don't think you can over tighten or make the gears mesh too hard unless you really tried.
andyandvirg 7 months ago
@andyandvirg i meshed the gears real good and its still not working, also there is no drive shaft missing.
Could this have something to do with the clutch?
LittleGreenMen0 7 months ago
@LittleGreenMen0 It must be, that's the only thing left in the drive system. If the motor is working but the gear is not turning then the clutch shoes can't be pushing out onto the clutch housing, or an internal shaft is broken.
andyandvirg 7 months ago
can the clutch be adjusted so it engages at slightly higher rpms?
shazrob22 1 year ago
@shazrob22 Not easily. All you could do is put a tighter or shorter clutch shoe spring on.
andyandvirg 1 year ago