Assembling the Phantastron Turret Board
Loading...
Loading...
2,420
Loading...
Uploaded by sheepslinky on Sep 22, 2008
Stop Motion and Video of assembling the Capacitors and Resistors on a Phantastron kit.
- 2 likes, 0 dislikes
-
Uploader Comments (sheepslinky)
see all
All Comments (1)
-
you should really heat your joints before you apply the solder. you can get cold joints that way.
Loading...
- 5:30
Phantastron Under Testby sheepslinky9,915 views
- 8:47
How To Build a Turret Board Part 2: Swage Fittingby TubeDepotTV6,808 views
- 3:51
ELECTRIC AMP USA Master Volume Units RULE !by ElectricAmpUSA3,757 views
- 5:28
VOX Hand-Wired AC30 Combo Amplifierby NstuffMusic24,337 views
- 3:20
The Thermatron Flame Controlled Synthesizerby sheepslinky7,195 views
- 6:24
Phantastron All Vacuum Tube Synthesizerby sheepslinky15,308 views
- 3:03
Shaw Amps 18 Watt Hand Built Tube Amp EF86 EL84by Fulltiltspeedways15,372 views
- 9:21
Drum Machine through the Phantastron!by sheepslinky2,470 views
- 0:40
Chieftain turret test on board film.by STEAMCAR849 views
- 3:04
Mike Patton plays the Intonarumoriby lucaliveshere87,005 views
- 6:13
Flying Lotus Interview - Apollo.be - On-Point.tvby lloydpointdexter46,399 views
- 1:09
Parker Steam Synthesizer - www.electricwestern.comby sheepslinky4,980 views
- 1:16
Rocket Parlour (Short Reel)by sheepslinky831 views
- 6:56
#117 Building the PWM v2, part 3 of 5by ZeroFossilFuel29,502 views
- 0:16
Rock out!by sheepslinky662 views
- 4:46
How to Do It: Basic Solderingby coldrestart856,665 views
- 10:59
How To Build a Classic British 18W Tube Guitar Amp Kitby TubeDepotTV86,195 views
- 0:50
PCB makingby JackUzi13105,784 views
- 1:56
Wire Tinning Method | BEST, Inc.by SolderingGeek10,652 views
- 1:52
Big Iron 34A by SimpleAmps2,557 views
I am aware. I'm using a pretty high temp lead free solder in this video which has a lot of flux to it. I set the Haco on a higher temp and it seems to flow really smoothly. I won't buy that solder again, I prefer the Kester, which works nicely and normally. I agree it's a bit weird, but that's how I get the most agreeable joints with this MG lead free (too little silver) mix.
Indeed, though, kids, solder to joint - not to iron, and heat the joint! You are right, sir.
sheepslinky 3 years ago