1/4 scale RC Hydro Flip from the outside #4A

Again we headed out, and again it was overcast, with a few props, the camera and the ATC3K camera used in the other crash video, as well as a few goodies. The motor was off tune after modifications to the exhaust stinger and I just couldn't get it right. There is still more speed to come!

Remember, this is a 1.2mtr or close to 4' replica (not race) hydro weighing in at around 11kgs (24 lbs)

Unfortunately, some pretty severe gusts of wind sprung up which made for some on the edge running. In this video I have framed a spin, an almost flip which luckily the turn fin grabbed and saved the boat and the final inverted flight.

Some serious damage was caused this time when a compression lock sheared the thin glass join and blew the deck clean off the boat. While it's off, more mods will happen and we'll try again!!!

Stay tuned .....................ENJOY

Please check out the other hydro flip video which is taken using the ATC3K on board camera..........fun fun fun!!

Category:

Sports

Tags:

• 1/4 scale
• Hydro
• Hydroplane
• crash
• flip
• Zenoah 1/4 scale hydro
• Large RC
• ATC3K

[tully712]

Geeeess that thing gained like 3 feet of air when it fliped

[123sqpbc321]

@tully712 Hey Tully, check out the other video using the helmet cam onboard!! Thanks mate

[FNQUIK01]

Nice! I saw one of these boats with a turbine engine n that was freaking amazing

[tully712]

Oh ya I did , I watched that one before this one, I was trying to figure out what happend at the end and then I saw this video.