Learn to Weld and Fit Pipe in This Welding Home Study Course

The Welders Lens welding home study course is a great place to learn how to weld and work with metal. Learn how to fit pipe. See the easy step by step fabrication of pipe and other metals with welding.

Category:

Education

Tags:

• the
• welders
• lens
• fit
• pipe
• learn
• how
• to
• weld
• stick
• welding

[lchilds82]

@00180mille why are all you welding fucks so fucking competitive, every single welding vid on here has some dick saying "this guy cant weld" blah blah blah

Cry much...............

[oldviolinat48]

put yourself a piece of angle iron for the fitting to set on while you tack it .

[TheLanden11]

My six year old son dose not stick rod as much as this guy doses

[Heavybag5525]

hu hu hey beavis

he said put your rod in the pipe!!

haha

[5quarter]

thats why the call it ..."stick welding"

[s46d45m17]

If you want to check side to side turn the elbow on it's side two hole the flange and make sure the face is level then get two 3/4 nuts and put them on each end of the 90 and set a level across them it will tell you if it needs to be hit up or down, this will be a good way to make sure it's fit good, After years of doing this you can get very close by just looking at the fitting and gap but factory ends alot of times are not very good so just looking at the gap is not the best way to fit it..

[azpipewelder]

Hope you don't follow any of this dudes advice you'll be better off

[LONGBEACHPUNKROCK]

Would NEVER Pass 100% X-Ray!!!!

Paint Is Contaminating the Weld!!!!!!!!

[KingVictorious27]

@starboy112 its a 90 elbow not a 40 foot pipe why would you square it just level it to your 2 hole. and as long as your land is fine from the factory and your gap is the close all the way around you dont need to touch it. just buff the paint off.

[jhayjakass]

hahahah.., full of blah blah blah .,., do it men

[MMilitia2006]

OMG.What a hack.hahahaha

[s46d45m17]

Sometimes I will lay the elbow on it's side and level the flange and take two 3/4 nuts and stand them up on the side of the elbow oposite ends of each other and set my level on top and then hit the elbow up or down because factory ends are not always true even on american fittings, good job fitting and welding by yourself I know how hard it is to hold level and tack been doing this for 23 years.