KWA SR12 SP150 Drop-in
Loading...
3,159
Loading...
Uploader Comments (hydralovr)
see all
All Comments (30)
-
if you swapped in a m150 why even bother putting the yellow sticker back on....unless this is a fake
-
Im not playing airsoft with you...
-
Kay Doubloo Aye?
-
you should change those bearing bushing to steel bushing because bearing bushings are known for breaking around 430 fps and your shooting 550 fps. i would rather buy a pair of steel bushings over a brand new gear set and maybe more
-
Did you shim the gearbox to use the sp150? Also how has the gearbox held up in the last 8-9 months?
Thanks
-
whats the bps
-
@hydralovr if it has an m120 and its still shoots like 410 420 then it must have a pretty good air seal
-
How has it held since you put the new spring in?
-
@hydralovr it shoots faster then my gun...
Loading...
Did you use the stock gearbox internals with the SP150 spring ?
stefanits1234 1 year ago
@stefanits1234 Yep.
hydralovr 1 year ago
Yeah, a 150 spring should be shooting in the 550 range. I was curious just how tough of a spring could be put into this gun without putting to much stress on the gearbox and motor and still give a good rate of fire. It comes stock with an M120 and still fires 400+FPS with a .20 gram so that's quite a jump. What gram BB's do you prefer with that spring? Probably a .30 or higher? Good to know I can just drop a stronger spring in. I think I'll go for M140. Any field testing or gearbox wear?
Jatodude1 1 year ago
@Jatodude1 Yep, I use BB King .30s. I'd like to go heavier, but I don't trust brands like Madbull. lol
I'll open up the gearbox after a while and see if there's anything bad going on.
hydralovr 1 year ago
chrono please? Because I honestly am not sure that a stock KWA could be pulling an SP150 with that ROF.
darthvader1995 1 year ago
@darthvader1995 I got it chronoed at ASGI and it shot 550 FPS.
hydralovr 1 year ago