Flywheel

Experimental

Category:

Entertainment

Tags:

• fuelless
• gravity
• engine
• experimental

[Marxmanster]

Hmm there is a faw with the design..

any appartus attached to it strong enough to move the wiegthed end would create a stable balancing point

[oneil3]

Thanks for the comment. We actually enhanced the design but we cannot find a solenoid strong enough to shift the weight.

[rblackwell2771]

use two weight that are connected. not one.

[rblackwell2771]

the fuelless gravity motor works. refer to robert kostoff. the patent can be found at freepatentsonline type in his name. patent called energy converter. it help to nuetralize the centrifugal forces to a point beyond the half way of the track so the weight is easier to result. These are easy to build!

[mareshalul]

New energy source: A chinese spining a wheel. Gooood,good. :|

[1100tech]

If you had 2 weights of equal amount ,across from each other , would cancel the effect of what you are talking about down to nothing and then the weights would work with the solenoid and using slip rings on the shaft would time the solenoids effort on the weights to the same point every rev. and you could incorporate a advancing device ,like a car distributor, and a generator,battery,to capture the energy transfer very interesting!

[caltropter]

Finally, proof of a new source of free energy; all you need is a guy to stand there and shift the weights around. In fact, people actually pay to do just that at gyms all across the world.

[mrgalleria]

Alo ha,

You got the idea.

Gravity fuel.

I have figured out a simple way to do it,

watch for my video.

Bill

[1100tech]

figured it out ...watch a steam train video and you'll figure it out too!

[1100tech]

OR a single rotary arm half the length of the total arm length you have there and the mount it on a bearing about half way out the arms length @ the 3 O'clock position this will allow the weight to be pulled in to the axle point @ the 9 O'clock position and push out to the end @ the 3 O'clock position and then use the chain to time and drive that

[1100tech]

OR a single rotary control arm half the length on the rotary arm you have there and then mount in a position @ 50% of the arms length @ the 3 O'clock postion this will pull it into the mid position @ the 9 O'clock position and push it out @ the 3 O'clock position