41,352
Loading...
Uploader Comments (1aauto)
see all
All Comments (42)
-
thank you for the video it help out alot an saved me money. Thank you again!
-
Great vedio thank you
-
THANK YOU!!!!!!!!!
-
@nomeddeeps The axle should come out of the hub as shown in the video. If the transmission end of the axle is fighting you a little bit, you can use a pry bar to help push it out of the transmission, it shouldn't take much pressure to come free from the tranny. Hope this helps you out.
-
@tonyjoke If it's giving you a hard time on the transmission end you can use a small pry bar to help push it out of the transmission. It shouldn't take a whole lot of pressure to remove it. Hope this helps you out.
Loading...
I just removed the top a-arm from the knuckle and was able to remove it with no problem. Thanks for all your help.
nomeddeeps 2 months ago
@nomeddeeps Thank you for checking us out. Have a great day!
1aauto 2 months ago
I cannot get the transmission end of the shaft to clear the spline. That is my problem. The hub part of the shaft is not my problem.
nomeddeeps 2 months ago
@nomeddeeps You should remove the hub side first as shown in the video, drop it down and then remove the other end from the transmission.
1aauto 2 months ago
i cant seem to get the axle out like you showed in the vid. cant get it pulled out far enough. any advice?
SDroogers 2 months ago
@SDroogers If you're having trouble on the hub bearing end, try to let the suspension hang down as far as it will go to see if it helps.
1aauto 2 months ago