1995 Jeep Wrangler with a Cummins 4bt
Uploader Comments (bedspins)
Top Comments
-
@mopar43v3r The scull shifter I made myself from some old harley shovelhead pistons. I cast it from a clay mold I made. It may be corny to you but its a one of a kind piece of art to me.
-
@marshall0792 I never really had it off road. Here in Western New York it's the snow that we need the 4 wheel drive for.
All Comments (235)
-
@1991JeepMan I was afraid of the mystical vibration that I was hearing about when I was building it. It runs way smoother that it did when it had the 4 banger in it. I have no idea what they were talking about.
-
@bedspins no way dude.... cat fucking murder's case on everything...
-
This is amazing. I bet that Wrangler rips a new one in the local trails. I am wanting to do a 4bt swap in a comanche SO badly. As soon as the wallet permits, that's my next project... right along side the 350 vortec swap into my Jeep XJ.
Quick question... I've heard a lot of people complain about the vibrations the 4bt puts out. Now, I'm not whimp, so some vibes and noise aren't going to kill me, but are the vibes as bad as people make them out to be? I appreciate any feedback!
-
@KPAracing No, I wanted a CASE under the hood. (they are yellow too)
building one curranty.. What tranny and t case you go with?
montagazzi8 2 months ago
@montagazzi8 AX-15 and stock transfer case. I did put a slip yoke eliminator kit in it.
bedspins 2 months ago
@bedspins which adapter plate is on the motor for running that?? Mine has a chevy now. Its going into a cherokee that currantly has a aw4 and 231 t case with sye. I have a sm465 at home and a nv3500 ..But a stock jeep ax15 prolly fits nice
montagazzi8 2 months ago
@montagazzi8 I have the Novak adapter with a toyota clutch slave. The SM465 has a 1 to 1 final drive. If you are putting a low rpm diesel in it, got with an overdrive. If its a daily driver, the AX-15 will hold up fine.
bedspins 2 months ago
Love everything but the huge body lift.... 1.25 inches is the highest i'd go... Did you put that big of a body lift on for looks or so the drivetrain would fit? If its the latter than ill stop complaining haha nice swap though!
Gocza1377 2 months ago
@Gocza1377 I had to go with the 3" lift because the engine is so tall. I installed it without any lift and the exhaust wouldn't clear the fire wall and the hood wouldn't close. I had to do it.
bedspins 2 months ago