Making Custom Made Fuel Lines
Loading...
Loading...
17,200
Loading...
1:55
No Door Handles - Just Touch!by SummitRacingVideos166,966 views- 3:25
Installing a Mallory Distributor - Two Guys Garageby SummitRacingVideos26,259 views
- 1:27
Control Arm Adjustment How-toby SummitRacingVideos2,309 views
- 0:31
Mallory Ignition Systemsby SummitRacingVideos3,936 views
- 4:28
Installing AN Hose Ends the easy wayby Speedsourceusa3,297 views
- 3:08
Crazy Car Wash!by CTFxC899,107 views
- 4:32
Elita Loresca - Nice & TIGHTby kaos21518,325 views
- 1:11
Perform-O-Flex & Auto-Flex hoseby HolleyPerformance2,881 views
- 9:54
How To Double Flare A Brake Or Fuel Lineby 2ton22012,938 views
- 1:45
The Best Way to Cut Braided AN Hoseby Speedsourceusa2,389 views
- 2:27
Fiberglassing (Car dash)by TheSnowboarderX34,638 views
- 6:47
Romania noastra faze tariby mrsica200914,072,907 views
- 1:06
Brake Tubing Pliers from Eastwoodby EastwoodCo63,982 views
- 6:49
Small Engine Repair: Checking Fuel Pump Diaphragm & Inlet Needle on a Diaphragm Carburetorby smallengineshop34,400 views
- 3:43
Flare Guide - AGS Companyby AGSCompany48,580 views
- 1:03
Chainsaw troubleshootingby jefflig14,827 views
- 10:01
Makin' Brake Lines Part 2by Longbox5513,351 views
- 1:08
JEGS Kenny Wallace Hose Fittingsby JEGSHighPerformance17,208 views
- 2:48
Rebar Cutting and Bending with Fascut FR-800-Cby FascutIndustries45,861 views
@BaalsJurisdiction Hahahaha! That's funny shit!
fenderspring 1 month ago
THAT WAS COOL!!
STREAKER123 2 months ago
@fenderspring there's a jumpcut and a change of camera angle when after he did, 50bucks he did smash his hand muhahaha
BaalsJurisdiction 2 months ago
That's a good way to destroy the edge of your chisel, much better to use a slightly softer material to back it up. I use a pneumatic high speed with a cutoff wheel while cutting through my masking tape on the hose. It doesn't deform the end and when clamped in a vice and makes for a safer and easier job. It would've been hilarious if he would have hammered his hand right after he said machismo!
fenderspring 7 months ago
thin cutting disc on a grinder gives a cleaner cut
1tufhk 8 months ago
He makes that look to easy, it really took me five hours and five bloody fingers to get one side in, I just gave up and just used a hose clamp to smash the tip, tgan I froze it and put it in, five minutes later I had oil all over my engine bay...
flamingaxe791 10 months ago