Stainless ring on homemade fangun... first run...

Custom made Stainless ring on homemade fangun snowmaker

Category:

Entertainment

Tags:

• fangun
• snow
• snowmaking
• snowgun
• stainless

[debow567]

Hi I was wondering what you did exactly, for the water supply ? Are you using a pump or just using a straight hose from the house? I also have a 30" fan and make a shroud around. But more concerned about te water set up? Thanks Devon...

[7hereverendmaynard]

@debow567 Using a cat310 setup - over kill pressure wise - since i run this gun at 150psi - but i use the 310 for my combos as well....

[7hereverendmaynard]

btw.... at my max flow i can start up with a 27 or so wetbulb....

[7hereverendmaynard]

i am water limited... so i only run my max.... whuch is rifht aroind 5.2gpm.... if i ever got additional supply, i could just segment the ring and add higher flowing nozzles.....

[TeRrAiNpArKDuDe]

how did u make the ring and how do the nozzles go into the ring? Also what is the barrel made out of?

[7hereverendmaynard]

@TeRrAiNpArKDuDe The ring started out as a 80" piece of 1.5", .065 Stainless tubing... I bent it using a tubing bender, and then drilled 24 holes into it at a 20* angle... I then cut 12 SS pipe nipples and welded them onto the ring. details can be found at snowguns dot com, in the fangun thread under my user name

[TeRrAiNpArKDuDe]

i notice in ur videos you have the gun with all the small tubes running to the gun and then i ring on it as well later. Which way works better?? Also what is all of the clear plastic and all of the connectors to the nozzles.

[crazyskier537]

Wow, this is great! Looks so clean and proffesional.

Now, wheres the whale?

Tim C

[Justbeatit999]

This looks very good, I am impressed. Just one question, how are going to adjust the flow rate? 

[TheDKLab]

@Zone5052 I want 10!!!