Petter genset start
Loading...
Loading...
7,569
Loading...
Uploader Comments (lamalandy)
see all
All Comments (4)
-
You will want to raise the frequency, or you are going to damage any inductive loads. Motors will overheat and burn out in no time at 37 Hz.
-
not sure how petters govern (assuming that there is even an internal governor!)but if its anything like a lister, you should be able to greatly tighten it up
-
That engine has a wonderful sound. I love the way it slowly spools up. :)
Loading...
1:10
Lister Two Cylinder Electric Start Diesel Generatorby billperry11267,212 views- 0:33
Petter PH2WRMR diesel engine start up.by dcoul120,567 views
- 1:18
Mamod model steam rollerby kw19843,519 views
- 0:25
your gensetby rahuldhinu4,982 views
- 0:57
Petter PAZ1 Start up - Run - Shut downby kw19846,520 views
- 2:53
Petter PAZ1 startup run and stop 2by angamoos4,576 views
- 0:38
Start up Caterpillar 3516 Gen Set V16by yoyodynepropulsion25,121 views
- 1:29
Petter S Stationary engineby hiliak24,860 views
- 0:25
Lister-Petter 3.0KVA Generator - Start-Up Processby MFMachineryUK11,889 views
- 0:08
Lister diesel runningby offgridder1136,780 views
- 1:14
Kubota EA300 Diesel Engine Start Upby hstats9,929 views
- 0:22
Petter S 5hpby Petterjunior13,422 views
- 1:46
Kubota Diesel Genset Test Startby photocontrol5,394 views
- 8:55
listerby itsst17230,217 views
- 4:07
Lister CS Stationary Engine running on Waste Vegetable Oilby homebrewpower19,507 views
- 3:00
Lister engine air startby hotrod373739,937 views
- 0:33
Priming a Lister Generatorby smellslikefries6,372 views
- 10:01
week 3 Gasifier and 10 kw generator startup (cold start)by foxridgecampground15,458 views
- 0:26
Petter AA1 Diesel engine not starting!by detroitdiesel331,329 views
- 2:12
AT502 Start Up on Dieselby evanccsmith60,201 views
The engine is driving the alternator through a 1:1 pulley, in the video the alternator is generating 1 KW AC at 37 Hz, this corresponds to 1110 RPM. The governor is not very good, the off load speed is very much higher than the on load speed and the cold speed.
lamalandy 3 years ago
what is the pulley ratio? sounds like its running under 1800 rpm
whoooru 3 years ago
The pulley ratio is 1:1, the engine is running at 1110 RPM, 37 Hz. The speed regulation is poor, in the film it is running with a 1KW load and cold. off load it runs at 1500 RPM when warm.
lamalandy 3 years ago