#19 PART1: Basic Tips for Hydroxy Dry Cell Construction

This video is to answer questions from people i have got regarding dry cell construction. Just basic tips i have from building them.

Category:

Science & Technology

Tags:

• hho
• hhoball
• hydroxy
• hyydrogen
• dry
• cell
• construction
• tips
• plates
• alternative
• energy
• gas
• fuel
• heat
• cooking
• heating
• torch
• drycell
• wetcell
• foaming

[mavelazquez]

Hi Jeff,

I am looking to construct a hho cell and I would like to ask you some questions: 1-why you add the neutral plates and 2- If the quantity of thesse neutral plates answer to some kind of calculation.

Thank very much for sharing your information

[hhoball]

@mavelazquez Neutral plates divide the voltage between each cell. Between each set of power plates, i use 5 neutral plates to divide the 13.8 volts, so i get between 2 and 2.3 volts per gap. Two power plates and 5 neutrals gives you 6 gaps. 13.8 / 6 = 2.3volts per gap.

Any further questions, just let me know

Jeff

[HYDROXYHARLIN]

Hi Jeff,

I am HARLIN and also building dry-cells, first many thanks for sharing

all this!!!

2nd We used Neoprene too but found out when the cell after many hours

production, the Neoprene doesn't shrink as fast as the 316l so there

is a risk of leakage, also there are indications that the H-atoms leaks

through the gaskets. We changed to EPDM and all the problems went away.

Again many thanks for your work

HARLIN

HYDROXY TECHNOLOGY NETHERLANDS

[hhoball]

@HYDROXYHARLIN Thanks! I will give that a try!

[1991SmokeyMcPot1991]

What material are you using to seperate each plate? is it just a large rubber o-ring ?

[hhoball]

@1991SmokeyMcPot1991 I am using 1/16" thick neoprene gaskets. It comes in a sheet and i cut them out using a knife. On larger cells i am using 1/8" thick.

[DutchUnited71]

@mavelazquez

Have a look at panacea.org

[DutchUnited71]

@1991SmokeyMcPot1991

What HHOBall says But we don't want the softness off the neoprene anymore. Any thoughts on the EPDM Jeff

[mavelazquez]

Hi jeff,

Thank you very much for your answer.

Im looking for all possible information I can get, to build a dry cell and I coulndt understand the function of neutral plates.

I am very much interested in the project of Stan Meyer, but done with injectors one for each cilynder. For now to start with, Im thinking in a dry cell to install in a vehicle just to aproach the subject.

Once I have something done I II let you know the results.

Many thanks (from Buenos Aires)

Miguel Velazquez

[richardlyew]

nice tip about the rubber washers, i wasn't thinking about that