EFIE and PWM Wiring Diagram for HHO Systems

If your a newbie (like me) and dont really know what goes where when it comes to wiring, check out this vid, it might help.

AH


Oh yea here are some links that have some good INFO & articles about EFIE and PWM stuff.

http://www.internationalhydroxy.com/articles/general-information/efie-electro...

http://www.fuelsaver-mpg.com/documents.html

http://hhohuntsville.com/Hho_electronics.html

http://www.internationalhydroxy.com/articles/general-information/efie-electro...


If anyone has any more good informational links, drop a line & I will post them here.


Oh and thanks to crob227 for informing that in line resetable circuit breakers you can be purchased at heating and are conditioning supply stores.

p.s. BTW I am not endorsing any products on these sites; just the information they contain. I cannot in all honesty endorse a company or product in which I have not purchased &/or tested.




Disclaimer:
Buyer beware - do some research, shop around and make an informed decision before you purchase anything. I am not liable for anything you do - stated or implied.

:D

Category:

Science & Technology

Tags:

• AlmostHydrogen
• EFIE
• PWM
• HHO
• Stanley
• Meyer
• EBN
• fuel
• cell
• booster
• browns
• gas
• water
• car

[apol732]

do i really need an efie?



[apol732]

thank you really helpful!!



[laylow597]

i would like to know why is there no line leaving your ignition switch.

[cerdopetoso]

well well i ting this is very interesting i live in mexico and really will like get this diagram ,pliss cull you send me this information and all you can about it

[frank0067]

I got an EFIE from fuelsaver-mpg year ago.. till now they havent helped me with ECU pinout or anything... feel bad about this company now

[patro46]

Hint...Hint....Your getting very close utilizing the PWM (one that you can adjust the pulse width frequency ONLY) over any form of direct current/cell design I have ever seen. If you want to take it further than a mere supplement to a gasoline engine, your going to need more. Much more. If you really want to destroy h2o and create enough hydrogen to run said vehicle, run your PWM output into a capacitor bank (wired in parallel) and increase the spacing between the anode and cathode plates.

[theFlashOracle]

great information just curious is the pwm necessary. does it do more than allow you to run the unit at a power lower than full power ?

[autocalidad]

@AlmostHydrogen

hy one question, what is the catalizator better for electroliser

sorry for my english because the peru

[72fordmaverick]

you should have the box with the PWM vented as a recomendation

[pmktbri]

could you use a old headlight switch from an automobile for a off & on ,potentiometer switch ?